scholarly journals The Ocean Colour Climate Change Initiative: I. A methodology for assessing atmospheric correction processors based on in-situ measurements

2015 ◽  
Vol 162 ◽  
pp. 242-256 ◽  
Author(s):  
Dagmar Müller ◽  
Hajo Krasemann ◽  
Robert J.W. Brewin ◽  
Carsten Brockmann ◽  
Pierre-Yves Deschamps ◽  
...  
2021 ◽  
Vol 13 (10) ◽  
pp. 1927
Author(s):  
Fuqin Li ◽  
David Jupp ◽  
Thomas Schroeder ◽  
Stephen Sagar ◽  
Joshua Sixsmith ◽  
...  

An atmospheric correction algorithm for medium-resolution satellite data over general water surfaces (open/coastal, estuarine and inland waters) has been assessed in Australian coastal waters. In situ measurements at four match-up sites were used with 21 Landsat 8 images acquired between 2014 and 2017. Three aerosol sources (AERONET, MODIS ocean aerosol and climatology) were used to test the impact of the selection of aerosol optical depth (AOD) and Ångström coefficient on the retrieved accuracy. The initial results showed that the satellite-derived water-leaving reflectance can have good agreement with the in situ measurements, provided that the sun glint is handled effectively. Although the AERONET aerosol data performed best, the contemporary satellite-derived aerosol information from MODIS or an aerosol climatology could also be as effective, and should be assessed with further in situ measurements. Two sun glint correction strategies were assessed for their ability to remove the glint bias. The most successful one used the average of two shortwave infrared (SWIR) bands to represent sun glint and subtracted it from each band. Using this sun glint correction method, the mean all-band error of the retrieved water-leaving reflectance at the Lucinda Jetty Coastal Observatory (LJCO) in north east Australia was close to 4% and unbiased over 14 acquisitions. A persistent bias in the other strategy was likely due to the sky radiance being non-uniform for the selected images. In regard to future options for an operational sun glint correction, the simple method may be sufficient for clear skies until a physically based method has been established.


Ocean Science ◽  
2015 ◽  
Vol 11 (1) ◽  
pp. 67-82 ◽  
Author(s):  
M. Ablain ◽  
A. Cazenave ◽  
G. Larnicol ◽  
M. Balmaseda ◽  
P. Cipollini ◽  
...  

Abstract. Sea level is one of the 50 Essential Climate Variables (ECVs) listed by the Global Climate Observing System (GCOS) in climate change monitoring. In the past two decades, sea level has been routinely measured from space using satellite altimetry techniques. In order to address a number of important scientific questions such as "Is sea level rise accelerating?", "Can we close the sea level budget?", "What are the causes of the regional and interannual variability?", "Can we already detect the anthropogenic forcing signature and separate it from the internal/natural climate variability?", and "What are the coastal impacts of sea level rise?", the accuracy of altimetry-based sea level records at global and regional scales needs to be significantly improved. For example, the global mean and regional sea level trend uncertainty should become better than 0.3 and 0.5 mm year−1, respectively (currently 0.6 and 1–2 mm year−1). Similarly, interannual global mean sea level variations (currently uncertain to 2–3 mm) need to be monitored with better accuracy. In this paper, we present various data improvements achieved within the European Space Agency (ESA) Climate Change Initiative (ESA CCI) project on "Sea Level" during its first phase (2010–2013), using multi-mission satellite altimetry data over the 1993–2010 time span. In a first step, using a new processing system with dedicated algorithms and adapted data processing strategies, an improved set of sea level products has been produced. The main improvements include: reduction of orbit errors and wet/dry atmospheric correction errors, reduction of instrumental drifts and bias, intercalibration biases, intercalibration between missions and combination of the different sea level data sets, and an improvement of the reference mean sea surface. We also present preliminary independent validations of the SL_cci products, based on tide gauges comparison and a sea level budget closure approach, as well as comparisons with ocean reanalyses and climate model outputs.


2015 ◽  
Vol 162 ◽  
pp. 271-294 ◽  
Author(s):  
Robert J.W. Brewin ◽  
Shubha Sathyendranath ◽  
Dagmar Müller ◽  
Carsten Brockmann ◽  
Pierre-Yves Deschamps ◽  
...  

2020 ◽  
Author(s):  
Alison Fowler ◽  
Jozef Skákala ◽  
Stefano Ciavatta

<p>Monitoring biogeochemistry in shelf seas is of great significance for the economy, ecosystems understanding and climate studies. Data assimilation can aid the realism of marine biogeochemistry models by incorporating information from observations. An important source of information about phytoplankton groups and total chlorophyll is available from the ESA OC-CCI (ocean colour - climate change initiative) dataset.</p><p>For any assimilation system to be successful it is important to accurately represent all sources of data uncertainty. For the ocean colour product, the propagation of errors throughout the ocean colour algorithm makes the characterisation of the uncertainty challenging. However, the problem can be simplified by assuming that the uncertainty is a function of optical water type (OWT), which characterises the water column of each observed pixel in terms of their reflectance properties.</p><p>Within this work we apply the well-known Desroziers et al. (2005) consistency diagnostics to the Met Office’s NEMOVAR 3D-VAR DA system used to create daily biogeochemistry forecasts on the North-West European Shelf. The derived estimates of monthly ocean colour error covariances stratified by OWT are compared to previously derived estimates of the root mean square errors and biases using in-situ data match ups (Brewin et al. 2017). It is found that the agreement between the two estimates of the error variances have a strong seasonal and OWT dependence. The error correlations (which can only be estimated with the Desroziers’ method) in some instances are found to be significant out to a few 100km particularly for more turbid waters during the spring bloom. The reliability and limitation of these two estimates of the ocean colour uncertainty are discussed along with the implications for the future assimilation of ocean colour products and for ecosystem and climate studies.</p>


Author(s):  
Garegin Tepanosayn ◽  
Vahagn Muradyan ◽  
Azatuhi Hovsepyan ◽  
Lilit Minasyan ◽  
Shushanik Asmaryan

Abstract The Sevan is one of the world’s largest highland lakes and the largest drinking water reservoir to the South Caucasus. An intensive drop in the level of the lake that occurred over the last decades of the 20th century has brought to eutrophication. The 2000s were marked by an increase in the level of the lake and development of fish farming. To assess possible effect of these processes on water quality, creating a state-ofthe- art water quality monitoring system is required. Traditional approaches to monitoring aquatic systems are often time-consuming, expensive and non-continuous. Thus, remote sensing technologies are crucial in quantitatively monitoring the status of water quality due to the rapidity, cyclicity, large-scale and low-cost. The aim of this work was to evaluate potential applications of the Landsat 8 Operational Land Imager (OLI) to study the spatio-temporal phytoplankton biomass changes. In this study phytoplankton biomasses are used as a water quality indicator, because phytoplankton communities are sensitive to changes in their environment and directly correlated with eutrophication. We used Landsat 8 OLI (30 m spatial resolution, May, Aug, Sep 2016) images converted to the bottom of atmosphere (BOA) reflectance by performing standard preprocessing steps (radiometric and atmospheric correction, sun glint removal etc.). The nonlinear regression model was developed using Landsat 8 (May 2016) coastal blue, blue, green, red, NIR bands, their ratios (blue/red, red/green, red/blue etc.) and in situ measurements (R2=0.7, p<0.05) performed by the Scientific Center of Zoology and Hydroecology of NAS RA in May 2016. Model was applied to the OLI images received for August and September 2016. The data obtained through the model shows that in May the quantity of phytoplankton mostly varies from 0.2 to 0.6g/m3. In August vs. May a sharp increase in the quantity of phytoplankton around 1-5 g/m3 is observable. In September, very high contents of phytoplankton are observed for almost entire surface of the lake. Preliminary collation between data generated with help of the model and in-situ measurements allows to conclude that the RS model for phytoplankton biomass estimation showed reasonable results, but further validation is necessary.


Author(s):  
Shubha Sathyendranath ◽  
Bob Brewin ◽  
Dagmar Mueller ◽  
Roland Doerffer ◽  
Hajo Krasemann ◽  
...  

2021 ◽  
Vol 14 (1) ◽  
pp. 83
Author(s):  
Xiaocheng Zhou ◽  
Xueping Liu ◽  
Xiaoqin Wang ◽  
Guojin He ◽  
Youshui Zhang ◽  
...  

Surface reflectance (SR) estimation is the most essential preprocessing step for multi-sensor remote sensing inversion of geophysical parameters. Therefore, accurate and stable atmospheric correction is particularly important, which is the premise and basis of the quantitative application of remote sensing. It can also be used to directly compare different images and sensors. The Landsat-8 Operational Land Imager (OLI) and Sentinel-2 Multi-Spectral Instrument (MSI) surface reflectance products are publicly available and demonstrate high accuracy. However, there is not enough validation using synchronous spectral measurements over China’s land surface. In this study, we utilized Moderate Resolution Imaging Spectroradiometer (MODIS) atmospheric products reconstructed by Categorical Boosting (CatBoost) and 30 m ASTER Global Digital Elevation Model (ASTER GDEM) data to adjust the relevant parameters to optimize the Second Simulation of Satellite Signal in the Solar Spectrum (6S) model. The accuracy of surface reflectance products obtained from the optimized 6S model was compared with that of the original 6S model and the most commonly used Fast Line-of-sight Atmospheric Analysis of Spectral Hypercubes (FLAASH) model. Surface reflectance products were validated and evaluated with synchronous in situ measurements from 16 sites located in five provinces of China: Fujian, Gansu, Jiangxi, Hunan, and Guangdong. Through the indirect and direct validation across two sensors and three methods, it provides evidence that the synchronous measurements have the higher and more reliable validation accuracy. The results of the validation indicated that, for Landsat-8 OLI and Sentinel-2 MSI SR products, the overall root mean square error (RMSE) calculated results of optimized 6S, original 6S and FLAASH across all spectral bands were 0.0295, 0.0378, 0.0345, and 0.0313, 0.0450, 0.0380, respectively. R2 values reached 0.9513, 0.9254, 0.9316 and 0.9377, 0.8822, 0.9122 respectively. Compared with the original 6S model and FLAASH model, the mean percent absolute error (MPAE) of the optimized 6S model was reduced by 32.20% and 15.86% for Landsat-8 OLI, respectively. On the other, for the Sentinel-2 MSI SR product, the MPAE value was reduced by 33.56% and 33.32%. For the two kinds of data, the accuracy of each band was improved to varying extents by the optimized 6S model with the auxiliary data. These findings support the hypothesis that reliable auxiliary data are helpful in reducing the influence of the atmosphere on images and restoring reality as much as is feasible.


Sign in / Sign up

Export Citation Format

Share Document