AbstractThe four kinds of TiCl4/MgCl2 type supported Ziegler-Natta catalysts, Cat-1, Cat-2, Cat-3 and Cat-4, were prepared by reaction of MgCl2-ethanol adduct with TiCl4. Cat-1 contains no internal electron donor (ID), Cat-2 contains diethyl phthalate (DEP) as ID, Cat-3 contains anisole as ID, and Cat-4 contains both DEP and anisole as ID. Ethylene copolymerizations with 1-hexene by these catalysts were compared. Influences of the internal electron donor on catalyst activity, copolymer composition, composition distribution, molecular weight and molecular weight distribution were investigated. Cat-3 showed the largest ability of incorporating 1-hexene into copolymer chains among the four catalysts. Each copolymer sample was fractionated into two fractions: fraction soluble in boiling nheptane (HS) and fraction insoluble in boiling n-heptane (HI). 1-Hexene content of the HS fraction is 6~10 times of that in the HI fractions. Amount of the HS fraction of copolymer by Cat-2 and Cat-4 was much lower than that of Cat-1 and Cat-3. Introduction of internal donor to the catalysts, especially diethyl phthalate (DEP), increased the blockiness of HI fractions. The molecular weight of both fractions increased when there is ID in the catalyst. Addition of anisole reduced the difference in molecular weight between HS fraction and HI fraction, but addition of PA enlarged the difference. The results are discussed based on a mechanistic model of MgCl2-supported Ziegler-Natta catalysts.
Propylene Polymerization over MgCl2
-Supported Ziegler-Natta Catalysts Containing Tri-Ether as the Internal Donor
