Wake formation behind a rolling sphere

2008 ◽  
Vol 20 (7) ◽  
pp. 071704 ◽  
Author(s):  
B. E. Stewart ◽  
T. Leweke ◽  
K. Hourigan ◽  
M. C. Thompson
2021 ◽  
Author(s):  
Mukhtarus Bahroinuddin ◽  
Rosihan Anwar

Abstract Based on NFPA-780, offshore platforms, which made from metal framework of a structure are thought of as "grounded" to the ocean and therefore are not needed to be installed external Lightning Protection System (LPS). PHE ONWJ which located at offshore tropic area has implemented NFPA 80 but still experience lightning hit. It generated fire at vent stack andcause operations interference. So that, the objective of this study is to redesign LPS for tropic area. Firstly, the methodology for this study was conducting literature review from previous researches for lightning protection system at tropic area and researches which underlyingNFPA-780. The literature reviews were focusing on lightning characteristic for tropic area andthe lightning density data from local lighting strike monitors surrounding PHE ONWJ. The result of literature reviews would be the basis of lightning strike event reviews in PHE ONWJ facilities. Subsequently, the authors conducted the equipment layout review using rolling sphere method based on previous lightning strike location. Lastly, Authors proposed the recommendationsfor typical LPS for oil and gas at tropic area. Based on literature reviews,lightning characteristic at tropic area has peak strike current twice the sub-tropic and longer "tail" so that the charge current is larger. Larger the charge current of lightning cause greaterimpact into metal structure that is metal melting. Based on NFPA 780/2011, the offshore platform, which is made by metal, and vessel with minimum thickness 4.8 mm are self-protected. However, based on calculation, with the characteristic of lightning at tropic area, the recommendedminimum vessel thickness is 10 mm. This calculation reinforces the fact that standard of Lightning Protection System in NFPA 780/2011 is not sufficient to be applied in tropic area like Indonesia. After calculating the tropic lightning strike range using rolling sphere method, it isrecommended to redesign lightning protection system for some locations at offshore platform and near shore facilities of PHE ONWJ.The lightning protections system locations and quantities are depending on the area and the needed protected equipment in it.The installation isincluding extended mast terminal, free standing mast, low inductive Double Shielded Down Conductor(DSDC), Lightning Event Counter (LEC), and good grounding system at the platform.


TRANSIENT ◽  
2019 ◽  
Vol 7 (4) ◽  
pp. 1091
Author(s):  
Vaneza Cindy Yolanda ◽  
Karnoto Karnoto ◽  
Hermawan Hermawan

Aspek keamanan, kenyamanan dan keselamatan menjadi salah satu faktor untuk mengukur tingkat kelayakan dari Stadion Citarum. Fenomena petir merupakan hal  yang patut diperhatikan untuk keselamatan pengguna di Stadion Citarum. Stadion merupakan bangunan yang memerlukan pemasangan sistem proteksi petir karena potensi bahaya akibat sambaran petir. Sistem proteksi petir yang belum memadai mendasari dilakukannya perancangan sistem proteksi petir untuk melindungi bangunan Stadion Citarum. Prosedur perhitungan sistem proteksi petir eksternal menggunakan standar IEC 62305-3, menggunakan radius Rolling Sphere, besar sudut Protection Angle dan lebar Mesh yang mengacu pada standar SNI 03-7015-2004. Sistem proteksi internal ditentukan berdasar kelas arrester/Surge Protective Device, dimana tegangan sisa yang masuk nilainya tidak boleh melebihi BIL Peralatan sebesar 2kV sesuai standar SNI 04-7021.21-2004. Penelitian ini menunjukkan hasil simulasi metode Rolling Sphere  memiliki area perlindungan paling baik, dengan radius 60 meter pada bangunan tribun menunjukkan bahwa air terminal yang terpasang sudah melindungi bangunan. Sistem proteksi petir internal menggunakan arrester / Surge Protective Device pada kelas 2.


2013 ◽  
Vol 135 (11) ◽  
Author(s):  
S. Kalyana Raman ◽  
K. Arul Prakash ◽  
S. Vengadesan

The bluff body simulations over canonical forms like circular and square cylinders are very well studied and the correlations for bulk parameters like mean drag coefficient and Strouhal numbers for the same are reported widely. In the case of elliptic cylinder, the literature is very sparse, especially for moderate Reynolds number (Re). Hence, in this work, a detailed study about fluid flow characteristics over an elliptic cylinder placed in a free stream is performed. Simulations are carried out for different Re ranging from 50 to 500 with axis ratio (AR) varied between 0.1 to 1.0 in steps of 0.1. Immersed boundary method is used for the solid boundary condition implementation which avoids the grid generation for each AR and a single Cartesian grid is used for all the simulations. The effect of AR for various Reynolds numbers is also focused on using the in-house code. The influence of AR is phenomenal for all the Re and the values of wake length, drag coefficient, and Strouhal number decrease with decreasing AR for a particular Re. The critical ARs, for vortex shedding and wake formation, are identified for various Re. Detailed correlations for wake length, critical ARs for vortex shedding and wake formation, mean drag coefficient and Strouhal number, in terms of AR, are reported in this work.


1991 ◽  
Vol 96 (A8) ◽  
pp. 13985-13995 ◽  
Author(s):  
S. Meassick ◽  
C. Chan ◽  
Y. Qian ◽  
T. Sroda ◽  
T. Azar ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document