Determination of PKvalues to the 172, 103 and 97 keV levels and the fluorescence yield ωKof Eu after electron capture by153Gd

1985 ◽  
Vol 11 (3) ◽  
pp. 399-405 ◽  
Author(s):  
K Singh ◽  
B S Grewal ◽  
H S Sahota
Keyword(s):  
Electron Capture ◽  
Fluorescence Yield

Determination of Hexachlorobenzene and Mirex in Fatty Products

1975 ◽  
Vol 58 (3) ◽  
pp. 557-561
Author(s):  
Rodney L Bong
Keyword(s):  
Petroleum Ether ◽  
Electron Capture ◽  
Methylene Chloride ◽  
Fats And Oils ◽  
Fat Injection ◽  
Liquid Chromatographic ◽  
Ppm Level

Abstract A procedure is described for the isolation and cleanup of hexachlorobenzene (HCB) and mirex in fats and oils for gas-liquid chromatographic (GLC) analysis. The fat or oil is distributed on unactivated Florisil, and the HCB and mirex are eluted with acetonitrile. The pesticides are then partitioned into petroleum ether. Elution through activated Florisil with methylene chloride-hexane (20+80) is used for the final cleanup. HCB and mirex are then measured by GLC, using the appropriate electron capture conditions with a 15% OV-210 column for HCB and a 3% OV-101 column for mirex. The method demonstrates recoveries greater than 90% for HCB and mirex and allows screening at or below the 0.1 ppm level in fats with a 3 mg fat injection.

Gas Chromatographic Determination of N-Butyl-N-ethyl-α,α,α-trifluoro-2,6-dinitro-p-toluidine and α,α,α-Trifluoro-2,6-dinitro-N,N-dipropyl-p-toluidine in Formulations

1971 ◽  
Vol 54 (3) ◽  
pp. 711-712
Author(s):  
Martha Fuzesi
Keyword(s):  
Gas Chromatography ◽  
Quantitative Determination ◽  
Electron Capture ◽  
Chromatographic Method ◽  
Chromatographic Determination ◽  
Electron Capture Detector ◽  
Reference Solution ◽  
Gas Chromatographic Method

Abstract A gas chromatographic method is described for the quantitative determination of N-butyl-N-ethyl-α,α,α-trifluoro-2,6-dinitro-p-tolindine and α,α,α-trifluoro-2,6-dinitro-N,N-dipropyI-p-toluidine herbicides in formulations. The sample is extracted with benzene, and equal amounts of sample and reference solution in the same concentration range are analyzed by gas chromatography, using an electron capture detector and an SE-30/Diatoport S column. The method has been applied successfully to laboratory-prepared and commercial samples.

Sign in / Sign up

Export Citation Format

Share Document