scholarly journals Cell-resolved blood flow simulations of saccular aneurysms: effects of pulsatility and aspect ratio

2018 ◽  
Vol 15 (146) ◽  
pp. 20180485 ◽  
Author(s):  
B. Czaja ◽  
G. Závodszky ◽  
V. Azizi Tarksalooyeh ◽  
A. G. Hoekstra

We study the effect of pulsatile flow on the transport of red blood cells (RBCs) and platelets into aneurysm geometries with varying dome-to-neck aspect ratios (AR). We use a validated two-dimensional lattice Boltzmann model for blood plasma with a discrete element method for both RBCs and platelets coupled by the immersed boundary method. Flow velocities and vessel diameters were matched with measurements of cerebral perforating arteries and flow was driven by a synthetic heartbeat curve typical for such vessel sizes. We observe a flow regime change as the aspect ratio increases from a momentum-driven regime in the small aspect ratio to a shear-driven regime in the larger aspect ratios. In the small aspect ratio case, we see the development of a re-circulation zone that exhibits a layering of high (greater than or equal to 7 s) and low (less than 7 s) residence cells. In the shear-driven regime, we see high and low residence cells well mixed, with an increasing population of cells that are trapped inside the aneurysm as the aspect ratio increases. In all cases, we observe aneurysms that are platelet-rich and red blood cell-poor when compared with their respective parental vessel populations. Pulsatility also plays a role in the small aspect ratio as we observe a smaller population of older trapped cells along the aneurysm wall in the pulsatile case when compared with a steady flow case. Pulsatility does not have a significant effect in shear-driven regime aspect ratios.

2017 ◽  
Vol 107 ◽  
pp. 65-82 ◽  
Author(s):  
M. Benioug ◽  
F. Golfier ◽  
C. Oltéan ◽  
M.A. Buès ◽  
T. Bahar ◽  
...  

Author(s):  
Heng Sun ◽  
David Ross

Purpose The MRT lattice Boltzmann simulation of natural convection in a confined environment is carried out. The flow and heat transfer during natural convection in a symmetrical annulus are studied. Design/methodology/approach The cavity is filled with TiO2-water nanofluid, and the thermal conductivity and dynamic viscosity of nanofluid are measured experimentally. The experimental data are utilized in the numerical simulations. The nanofluids are prepared at four different nanoparticle concentrations φ = 0, 0.1, 0.3 and 0.5. It is notable that the radial coordinate is used into the temperature distribution function. As a result, only one source term is required for the present lattice Boltzmann model. On the other hand, the macro cylindrical energy equation is exactly recovered using Chapman–Enskog analysis. Findings Influence of some main parameters including Rayleigh number in range of 103 to 106, solid volume fraction of nanofluid in range of 0 to 0.5 and four different aspect ratios on the the nanofluid flow (i.e. streamlines), heat transfer (i.e. temperature distribution and average Nusselt number) and entropy generation (i.e. total entropy generation and Bejan number) are presented, quantitatively and graphically. It is found that adding TiO2 nanoparticles to the base fluid has considerable positive effect on the heat transfer performance and entropy generation. In addition, the configuration of the annulus can be good controlling parameter on the heat transfer rate during natural convection. Originality/value The originality of this work is using of a modern numerical method to simulate the free convection and conducting experimental observations to calculate the thermo-physical properties of nanofluid. In addition, the numerical and experimental works are combined to provide accurate results.


2012 ◽  
Vol 98 (3) ◽  
pp. 34001 ◽  
Author(s):  
A. F. Di Rienzo ◽  
P. Asinari ◽  
E. Chiavazzo ◽  
N. I. Prasianakis ◽  
J. Mantzaras

Sign in / Sign up

Export Citation Format

Share Document