In Vitro Investigation of the Impact of Aortic Valve Stenosis Severity on Left Coronary Artery Flow

2010 ◽  
Vol 132 (4) ◽  
Author(s):  
E. Gaillard ◽  
D. Garcia ◽  
L. Kadem ◽  
P. Pibarot ◽  
L.-G. Durand

Patients with aortic valve stenosis (AS) may experience angina pectoris even if they have angiographically normal coronary arteries. Angina is associated with a marked increase in the risk of sudden death in AS patients. Only a few in vitro models describing the interaction between the left ventricular and aortic pressures, and the coronary circulation have been reported. These models were designed for specific research studies and they need to be improved or modified when other specific studies are required. Consequently, we have developed an in vitro model that is able to mimic the coronary circulation in presence of aortic stenosis. First, we have validated the model under physiological conditions. Then, we have examined and quantified the hemodynamic effects of different degrees of AS (from normal to severe AS) on the coronary flow using a model of the normal left coronary artery. In the coronary in vitro model without AS (normal valve), the amplitude and shape of coronary flow were similar to those observed in in vivo measurements obtained under physiological conditions, as described by Hozumi et al. (1998, “Noninvasive Assessment of Significant Left Anterior Descending Coronary Artery Stenosis by Coronary Flow Velocity Reserve With Transthoracic Color Doppler Echocardiography,” Circulation, 97, pp. 1557–1562). The presence of an AS induced an increase in the maximum and mean coronary flow rates (97% and 73%, respectively, for a very severe AS). Furthermore, when AS was very severe, a retrograde flow occurred during systole. This study allowed us to validate our coronary in vitro model under physiological conditions, both in the absence and presence of AS. These changes could explain the fact that even if patients have angiographically normal epicardial coronary arteries, we can observe the occurrence of angina pectoris in these patients in the presence of an AS.

1982 ◽  
Vol 104 (3) ◽  
pp. 221-225 ◽  
Author(s):  
H. N. Sabbah ◽  
P. D. Stein

The dynamics of retrograde coronary flow in aortic valvular stenosis was investigated in an in-vitro pulse duplicating system which had the capability of simulating coronary flow. The ventricular chamber of the pulse duplicator consisted of an opaque elastic sac molded from rubber in the shape of a left ventricle. The aortic test section consisted of an acrylic mold of the root of the aorta of a calf, which included the sinuses of Valsalva and the entrance region of both the left and right coronary arteries. Flow in the left coronary artery was modeled to deliver both a systolic and a diastolic component of flow. Studies were performed with normal porcine valves in the aortic and mitral positions and were repeated with a human stenotic valve in the aortic position. Pressures were measured in the aorta, left ventricle, and at the ostium of the left coronary artery with catheter-tip micromanometers. In the presence of a normal aortic valve, total coronary flow was adjusted to 120 ml/min of which 21 percent of the flow occurred during systole. The phasic pattern of coronary flow was similar to that shown in vivo. In the presence of a stenotic aortic valve, a small amount of retrograde coronary flow (<1 percent of total coronary flow) was observed; and this occurred during the initial phase of systole. Retrograde coronary flow during systole appears to have resulted from compression of the collapsible segment of the simulated coronary artery. This was caused by the elevated simulated intramural pressure.


2008 ◽  
Vol 41 ◽  
pp. S392
Author(s):  
Emmanuel Gaillard ◽  
Lyes Kadem ◽  
Philippe Pibarot ◽  
Louis-Gilles Durand

1991 ◽  
Vol 26 ◽  
pp. S101-S102
Author(s):  
ERIC F. GRABOWSKI ◽  
SONAM L. McDONNELL ◽  
COLE THOMSON ◽  
MARISOL RODRIGUEZ

Author(s):  
Abhijit Sinha Roy ◽  
Lloyd H. Back ◽  
Ronald W. Millard ◽  
Saeb Khoury ◽  
Rupak K. Banerjee

Simultaneous measurement of pressure and flow rate has been found to be helpful in evaluating the physiologic significance of obstructive coronary artery disease and in the diagnosis of microvascular disease. This experimental study seeks to find important pressure-flow relationship in an in-vitro model of significant coronary artery stenoses using a non-Newtonian liquid, similar to blood showing a shear thinning behavior, using significant stenotic in-vitro model (minimal area stenosis = 90%). The geometry for the stenotic model is based on data provided in an in vivo study by Wilson et al., (1988). For 90% area stenosis, the maximum recorded pressure drop for steady flow rate of 55, 79 and 89 are 14, ~24 and ~32 mmHg respectively. The maximum pressure drop at flow rate of 115 ml/min (the physiological limit) is 50.3 mmHg respectively. Using a power law curve fit, the maximum pressure drop (in mmHg) related with flow rate (in ml/min) provided a power law index of 1.72. Shorter distal length than required in the in-vitro model did not allow the recording of complete pressure recovery. This preliminary data provides reference values for further experimentation both in vitro with pulsatile flow as in physiological conditions, and in vivo.


2019 ◽  
Vol 122-123 ◽  
pp. 106583
Author(s):  
A. Zabirnyk ◽  
M.D. Ferrer ◽  
M. Bogdanova ◽  
M.M. Pérez ◽  
C. Salcedo ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document