scholarly journals Dissipative Scale Effects in Strain-Gradient Plasticity: The Case of Simple Shear

2016 ◽  
Vol 76 (2) ◽  
pp. 688-704 ◽  
Author(s):  
Maria Chiricotto ◽  
Lorenzo Giacomelli ◽  
Giuseppe Tomassetti
2020 ◽  
Vol 87 (3) ◽  
Author(s):  
Carl F. O. Dahlberg ◽  
Michael Ortiz

Abstract A recently developed model based on fractional derivatives of plastic strain is compared with conventional strain-gradient plasticity (SGP) models. Specifically, the experimental data and observed model discrepancies in the study by Mu et al. (2016, “Dependence of Confined Plastic Flow of Polycrystalline Cu Thin Films on Microstructure,” MRS Com. Res. Let. 20, pp. 1–6) are considered by solving the constrained simple shear problem. Solutions are presented both for a conventional SGP model and a model extension introducing an energetic interface. The interface allows us to relax the Dirichlet boundary condition usually assumed to prevail when solving this problem with the SGP model. We show that the particular form of a relaxed boundary condition does not change the underlying size scaling of the yield stress and consequently does not resolve the scaling issue. Furthermore, we show that the fractional strain-gradient plasticity model predicts a yield stress with a scaling exponent that is equal to the fractional order of differentiation.


2012 ◽  
Vol 72 (4) ◽  
pp. 1169-1191 ◽  
Author(s):  
Maria Chiricotto ◽  
Lorenzo Giacomelli ◽  
Giuseppe Tomassetti

2009 ◽  
Vol 50 (3) ◽  
pp. 407-420
Author(s):  
ROGER YOUNG

AbstractAn analytic solution is developed for the one-dimensional dissipational slip gradient equation first described by Gurtin [“On the plasticity of single crystals: free energy, microforces, plastic strain-gradients”, J. Mech. Phys. Solids48 (2000) 989–1036] and then investigated numerically by Anand et al. [“A one-dimensional theory of strain-gradient plasticity: formulation, analysis, numerical results”, J. Mech. Phys. Solids53 (2005) 1798–1826]. However we find that the analytic solution is incompatible with the zero-sliprate boundary condition (“clamped boundary condition”) postulated by these authors, and is in fact excluded by the theory. As a consequence the analytic solution agrees with the numerical results except near the boundary. The equation also admits a series of higher mode solutions where the numerical result corresponds to (a particular case of) the fundamental mode. Anand et al. also established that the one-dimensional dissipational gradients strengthen the material, but this proposition only holds if zero-sliprate boundary conditions can be imposed, which we have shown cannot be done. Hence the possibility remains open that dissipational gradient weakening may also occur.


Sign in / Sign up

Export Citation Format

Share Document