Flexure-shear behavior of precast concrete deck panels with cast-in-place concrete topping

PCI Journal ◽  
2011 ◽  
Vol 56 (3) ◽  
pp. 60-74 ◽  
Author(s):  
Robert K. Dowell ◽  
Roy Auer
PCI Journal ◽  
2007 ◽  
Vol 52 (1) ◽  
pp. 16-30
Author(s):  
James W. Carter ◽  
Tom Pilgrim ◽  
Finn K. Hubbard ◽  
Tim Poehnelt ◽  
Michael Oliva

2010 ◽  
Vol 15 (5) ◽  
pp. 482-492 ◽  
Author(s):  
Sameh S. Badie ◽  
Amgad F. Morgan Girgis ◽  
Maher K. Tadros ◽  
Nghi T. Nguyen

2016 ◽  
Vol 21 (6) ◽  
pp. 05016001 ◽  
Author(s):  
Niranjan Pai ◽  
Ivan Gualtero ◽  
Atiq Alvi ◽  
Rajan Sen ◽  
Gray Mullins

2014 ◽  
Vol 19 (5) ◽  
pp. 05014001 ◽  
Author(s):  
Korin M. Holden ◽  
Chris P. Pantelides ◽  
Lawrence D. Reaveley

Author(s):  
Alex Harrison ◽  
N. David LeBlanc

The West Sandusky Street Bridge over I-75 in Findlay, Ohio, consisted of a single 170-ft-span hybrid steel plate girder bridge with a concrete deck. To minimize closure times on West Sandusky Street and reduce traffic delays on I-75 during the bridge's replacement, full-width, full-depth precast concrete deck panels were proposed for the bridge deck construction. The precast deck panels are posttensioned both longitudinally and transversely to minimize cracking and improve durability and are constructed with shear stud pockets to allow for the installation of shear studs after erection and posttensioning. During detail design, a finite element analysis of the bridge deck was carried out to determine the required level of prestress in the deck. A time-dependent analysis was subsequently completed to determine the long-term creep effects and posttensioning losses, including the effects of restraint from the steel girders. A sensitivity analysis determined the optimum curing time required before stressing the longitudinal posttensioning tendons and grouting the shear pockets. The steel plate girders were designed for the long-term creep effects due to the posttensioning of the deck, which imposed additional axial loads and moments on the steel girders. The replacement deck panels were fabricated before bridge demolition and road closure. Bridge construction was completed in fall 2004.


2018 ◽  
Vol 8 (12) ◽  
pp. 2598 ◽  
Author(s):  
Haiying Ma ◽  
Xuefei Shi ◽  
Yin Zhang

Twin-I girder bridge systems composite with precast concrete deck have advantages including construction simplification and improved concrete strength compared with traditional multi-I girder bridge systems with cast-in-place concrete deck. But the cracking is still a big issue at interior support for continuous span bridges using twin-I girders. To reduce cracks occurrence in the hogging regions subject to negative moments and to guarantee the durability of bridges, the most essential way is to reduce the tensile stress of concrete deck within the hogging regions. In this paper, the prestressed tendons are arranged to prestress the precast concrete deck before it is connected with the steel girders. In this way, the initial compressive stress induced by the prestressed tendons in the concrete deck within the hogging region is much higher than that in regular concrete deck without prestressed tendons. A finite element analysis is developed to study the long-term behaviour of prestressed concrete deck for a twin-I girder bridge. The results show that the prestressed tendons induce large compressive stresses in the concrete deck but the compressive stresses are reduced due to concrete creep. The final compressive stresses in the concrete deck are about half of the initial compressive stresses. Additionally, parametric study is conducted to find the effect to the long-term behaviour of concrete deck including girder depth, deck size, prestressing stress and additional imposed load. The results show that the prestressing compressive stress in precast concrete deck is transferred to steel girders due to concrete creep. The prestressed forces transfer between the concrete deck and steel girder cause the loss of compressive stresses in precast concrete deck. The prestressed tendons can introduce some compressive stress in the concrete deck to overcome the tensile stress induced by the live load but the force transfer due to concrete creep needs be considered. The concrete creep makes the compressive stress loss and the force redistribution in the hogging regions, which should be considered in the design the twin-I girder bridge composite with prestressed precast concrete deck.


Sign in / Sign up

Export Citation Format

Share Document