scholarly journals Chirp Signal Denoising Based on Convolution Neural Network

2020 ◽  
Author(s):  
Ben Guangli ◽  
Xifeng Zheng ◽  
Yongcheng Wang ◽  
Xin Zhang ◽  
Ning Zhang

Abstract Many classical chirp signal processing algorithm may experience distinct performance decrease in noise circumstance. To address the problem, this paper proposes a deep learning based approach to filter noises in time domain. The proposed denoising convolutional neural network (DCNN) is trained to recover the original clean chirps from observation signals with noises. Following denosing, we employ two parameter estimation algorithm to DCNN output. Simulation result show that the proposed DCNN method improves the signal noise ratio (SNR) and parameter estimation accuracy to a great extent compared to the signals without denoising. And DCNN have a strong adaptability of low SNR input scenarios that never trained.

2021 ◽  
Vol 21 (1) ◽  
pp. 33-38
Author(s):  
Peng Chen ◽  
Qin Chen ◽  
Zhijun Xie ◽  
Xiaohui Chen ◽  
Shaomei Zhao

Abstract In this paper, a computationally efficient and high precision parameter estimation algorithm with frequency-time combination is proposed to improve the estimation performance for sinusoidal signal in noise, which takes the advantages of frequency- and time-domain algorithms. The noise influence is suppressed through spectrum analysis to get coarse frequency, and the fine frequency is obtained by denoising filtering and using linear prediction property. Then, estimation values of the amplitude and initial phase are obtained. The numerical results indicate that the proposed algorithm makes up for the shortcomings of frequency- and time-domain algorithms and improves the anti-interference performance and parameter estimation accuracy for sinusoidal signal.


2014 ◽  
Vol 599-601 ◽  
pp. 1474-1477
Author(s):  
Xin Chen ◽  
Min Tao ◽  
Tian Tang Pan ◽  
Yan Li

The Chirp signal has been used widely in radar signal, radar echo wave can established to be Chirp model. The estimation of radar echo wave parameter is a important task in radar signal processing. In this paper, we introduced three theories and algorithms of detection and estimation of Chirp signal: 2D peak searching algorithm, two steps searching of maximum value algorithm and pre-estimation algorithm firstly. The parameter estimation precision and computation complexity in low SNR was simulated for these three algorithms. The final simulation indicate that the two steps searching algorithm of maximum value take on nice estimation accuracy and low computation complexity in contrast.


2014 ◽  
Vol 14 (3) ◽  
pp. 126-135 ◽  
Author(s):  
Qian Wang ◽  
Xiao Yan ◽  
Kaiyu Qin

Abstract Based on enhanced interpolation DFT, a novel parameter estimation algorithm for the exponential signal is presented. The proposed two-step solution consists of a preprocessing unit which constructs a new signal sequence by continuously cycle shifting sample points and summing up N buffered exponential signal sample sequences, then an interpolation DFT engine to obtain accurate parameter estimation of the exponential signal based on the signal sequence generated by the preprocessing unit. Compared to previous works, owing to the combination of the pretreatment and the interpolation DFT analysis, the tedious iteration for spectral leakage elimination can be removed, and remarkable improvements are achieved in terms of estimation accuracy and speed. The simulation results verify the effectiveness of the proposed algorithm.


Sign in / Sign up

Export Citation Format

Share Document