Анизотропия магнитоэлектрических свойств объемных композитов феррит-пьезоэлектрик

AbstractThe anisotropy of magnetoelectric properties of lead zirconate–titanate and nickel ferrite based bulk composites has been experimentally studied. It has been shown that a ratio of longitudinal to transverse magnetoelectric coefficients is affected by the piezoelectric constant of a composite. The mechanism that explains the obtained dependences has been suggested; the mechanism is based on the assumption that the anisotropy of magnetic properties is caused by the deformation occurring at electric polarization of a sample.

Download Full-text

Structure and phase formation behavior and dielectric and magnetic properties of lead iron tantalate-lead zirconate titanate multiferroic ceramics

Materials Research Bulletin ◽

10.1016/j.materresbull.2015.11.045 ◽

2016 ◽

Vol 75 ◽

pp. 91-99 ◽

Cited By ~ 1

Author(s):

R. Wongmaneerung ◽

R. Tipakontitikul ◽

P. Jantaratana ◽

A. Bootchanont ◽

J. Jutimoosik ◽

...

Keyword(s):

Magnetic Properties ◽

Phase Formation ◽

Lead Zirconate Titanate ◽

Lead Zirconate ◽

Zirconate Titanate ◽

Formation Behavior

Download Full-text

Lead zirconate titanate-nickel zink ferrite thick-film composites: obtaining by the screen printing technique and magnetoelectric properties

Technical Physics ◽

10.1134/s1063784210030096 ◽

2010 ◽

Vol 55 (3) ◽

pp. 387-394 ◽

Cited By ~ 14

Author(s):

A. A. Bush ◽

V. Ya. Shkuratov ◽

I. A. Chernykh ◽

Y. K. Fetisov

Keyword(s):

Thick Film ◽

Lead Zirconate Titanate ◽

Screen Printing ◽

Lead Zirconate ◽

Magnetoelectric Properties ◽

Zirconate Titanate ◽

Screen Printing Technique ◽

Printing Technique ◽

Film Composites

Download Full-text

Dielectric and magnetic properties of lead zirconate titanate/Ni ferrite composites

Materials Research Innovations ◽

10.1179/143307511x13085642037664 ◽

2011 ◽

Vol 15 (4) ◽

pp. 244-248 ◽

Cited By ~ 1

Author(s):

J L Chen ◽

Z Xu ◽

B K Wang ◽

X Yao

Keyword(s):

Magnetic Properties ◽

Lead Zirconate Titanate ◽

Lead Zirconate ◽

Zirconate Titanate ◽

Ferrite Composites

Download Full-text

Measurements of Piezoelectric Constant D33 of Lead Zirconate Titanate (PZT) Through Use of a Mini Impact Hammer

Volume 6: ASME Power Transmission and Gearing Conference; 3rd International Conference on Micro- and Nanosystems; 11th International Conference on Advanced Vehicle and Tire Technologies ◽

10.1115/detc2009-86157 ◽

2009 ◽

Author(s):

Qing Guo ◽

G. Z. Cao ◽

I. Y. Shen

Keyword(s):

Thin Films ◽

Boundary Conditions ◽

Lead Zirconate Titanate ◽

Low Cost ◽

Lead Zirconate ◽

Piezoelectric Constant ◽

Impulsive Force ◽

Sensors And Actuators ◽

Aspect Ratios ◽

Zirconate Titanate

Lead Zirconate Titanate Oxide (PbZrxTi1−xO3 or PZT) is a piezoelectric material widely used as sensors and actuators. For microactuators, PZT often appears in the form of thin films to maintain proper aspect ratios. This paper is to present a simple and low-cost method to measure piezoelectric constant d33 of PZT thin films, which is a major challenge encountered in the actuator development. We use an impact hammer with a sharp tip to generate an impulsive force that acts on the PZT film. The impulsive force and the responding voltage are then measured to calculate the piezoelectric constant d33. The impulsive force has large enough amplitude so that a good signal-to-noise ratio can be maintained. Furthermore, the impulsive force has extremely short duration, so the discharge effect (i.e., the time constant effect) of the PZT circuit can be ignored. Preliminary testing on bulk PZT through this new method leads to two conclusions. Firstly, boundary conditions of the specimen are critical. In particular, the specimen must be securely fastened. Since the impulsive load only acts on a tiny area, loose boundary conditions can introduce spurious results from other piezoelectric constant d31. Secondly, size of the specimen is critical. Specimen of smaller size leads to more accurate measurements of the piezoelectric constant d33.

Download Full-text