scholarly journals Destressing MOSFETs by Series Connection in Low Gain Buck Converters

Author(s):  
Walid Issa ◽  
Jose Ortiz-Gonzalez ◽  
Yihua Hu

<p>Low-gain buck converters will enable low voltage loads to access high voltage DC sources by a single stage converter at very low duty cycles. SiC MOSFETs are still limited to 1.7kV commercially and by seriesing them with adequate gate driving strategy, high voltages can be switched. This paper proposes a driving circuit for series SiC MOSFETs to block higher voltages. The driving circuit provides negative off-state voltage and turn on/off transitions in less than 100ns. The low-gain buck converter performance is assessed when using a single IGBT switch and series SiC MOSFETs. A simulation is implemented and shows the superiority of the proposed driven series SiC MOSFETs with distributed voltage and thermal stresses.</p>

2021 ◽  
Author(s):  
Walid Issa ◽  
Jose Ortiz-Gonzalez ◽  
Yihua Hu

<p>Low-gain buck converters will enable low voltage loads to access high voltage DC sources by a single stage converter at very low duty cycles. SiC MOSFETs are still limited to 1.7kV commercially and by seriesing them with adequate gate driving strategy, high voltages can be switched. This paper proposes a driving circuit for series SiC MOSFETs to block higher voltages. The driving circuit provides negative off-state voltage and turn on/off transitions in less than 100ns. The low-gain buck converter performance is assessed when using a single IGBT switch and series SiC MOSFETs. A simulation is implemented and shows the superiority of the proposed driven series SiC MOSFETs with distributed voltage and thermal stresses.</p>


Author(s):  
Hussain Sayed ◽  
Oday A Ahmed ◽  
Dhari Y Mahmood ◽  
Kanaan A. Jalal ◽  
Waleed H. Habeeb

<span>A single-stage symmetrical high voltage gain half-bridge (HB) DC-AC converter is proposed in this paper. Using two Y-source impedance networks, the following key features are utilized from the proposed topology: single stage inverter with very high voltage gain compared to conventional HB inverter, symmetrical output voltage waveform, low voltage stress across the passive components because it is distributed across two impedance networks, and only two switching devices are needed for the converter. Furthermore, important merit of the proposed topology is that the current drawn by the Y-coupled inductors is symmetrical around the X-axis which helps to prevent the Y-network cores from reaching the saturation state. And the last compelling feature is a virtual neutral point for the load connection is inherited in the proposed double Y-source impedance networks converter with no need for DC-Link capacitors. For low voltage sources such as photovoltaic (PV) and fuel cell, the converter is designed to achieve continuous input current operation. The operation modes and principles of the inverter are analyzed and discussed deeply in this paper. A detailed mathematical equations system is derived and verified for the presented converter. Finally, PSpice simulation tools are used to simulate the converter and verify the derived mathematical formulas.</span>


2009 ◽  
Vol 129 (8) ◽  
pp. 1511-1517
Author(s):  
Nicodimus Retdian ◽  
Jieting Zhang ◽  
Takahide Sato ◽  
Shigetaka Takagi

Sign in / Sign up

Export Citation Format

Share Document