Study on Fatigue Crack Growth Rate of Welded Joint of Duplex Stainless Steel

2011 ◽  
Vol 291-294 ◽  
pp. 941-944
Author(s):  
Zheng Lun Wang ◽  
Zhi Xiang Wang

The fatigue crack growth behavior of weld metal (WM), heat affected zone(HAZ) and base metal(BM) of Duplex Stainless Steel 2205(DSS) has been determined at high-frequency fatigue testing machine. The results show that the fatigue crack growth rate of WM is slowest and the ability to resist fatigue crack growth is highest in the three parts. Secondly, the sensitivity caused by the stress change of WM is the highest, followed by HAZ, and the BM is the weakest.

2012 ◽  
Vol 503-504 ◽  
pp. 991-994
Author(s):  
Zhi Xiang Wang ◽  
Zheng Lun Wang ◽  
Xin Zhang

The fatigue crack growth behavior of weld metal (WM), heat affected zone (HAZ) and base metal(BM) of Duplex Stainless Steel (DSS) 2205 standard sample was tested in different stress ratios at HF fatigue testing machine. ANSYS analysis software was used to simulate the fatigue crack growth rate of the steel under different stress ratio. Regression equations and da / dK-ΔK curves of experiment and simulation are compared and analyzed. The results show that the fatigue crack growth rate of WM is slowest and the ability to resist fatigue crack growth is highest among the three parts, the lowest is BM. Secondly, the sensitivity of the rate caused by the stress change of WM is the highest, and the lowest is BM. The simulation of fatigue crack growth rate of DSS 2205 is completely correct and feasible by the experiment.


Sign in / Sign up

Export Citation Format

Share Document