Discrete Optimization of Structures under Dynamic Loading by using Sequential and Parallel Evolution Strategies

2009 ◽  
Author(s):  
J. Cai ◽  
G. Thierauf
Keyword(s):  
Dynamic Loading ◽  
Discrete Optimization ◽  
Parallel Evolution ◽  
Evolution Strategies

Parallel Evolution Strategies

2005 ◽  
pp. 155-169 ◽  
Author(s):  
Günter Rudolph
Keyword(s):  
Parallel Evolution ◽  
Evolution Strategies

MODES OF FAILURE OF MATERIALS UNDER THE DYNAMIC LOADING

1988 ◽  
Vol 49 (C3) ◽  
pp. C3-295-C3-299
Author(s):  
J. SUVOROVA
Keyword(s):  
Dynamic Loading ◽  
Modes Of Failure

Reverse torque values of abutment screws after dynamic loading: The effects of sealant agents and the taper of conical connections

2020 ◽  
Author(s):  
Arda Ozdiler ◽  
suleyman dayan ◽  
Burc Gencel ◽  
Gulbahar Isık-Ozkol
Keyword(s):  
Dynamic Loading ◽  
Antibacterial Agent ◽  
In Vitro Study ◽  
Control Group ◽  
Silicone Sealant ◽  
Reverse Torque ◽  
The Stability ◽  
Torque Values ◽  
Chlorhexidine Gel

This in vitro study evaluated the influence of taper angles on the internal conical connections of implant systems and of the application of chlorhexidine gel as an antibacterial agent or a polyvinyl siloxane (PVS) sealant on the reverse torque values of abutment screws after dynamic loading. The current study tested four implant systems with different taper angles (5.4°, 12°, 45°, and 60°). Specimens were divided into three groups: control (neither chlorhexidine gel filled nor silicone sealed), 2% chlorhexidine gel-filled or silicone-sealed group, and group subjected to a dynamic load of 50 N at 1 Hz for 500,000 cycles prior to reverse torque measurements. Quantitative positive correlation was observed between the taper angle degree and the percentage of tightening torque loss. However, this correlation was significant only for the 60° connection groups except in the group in which a sealant was applied ( p = 0.013 for the control group, p = 0.007 for the chlorhexidine group). Percentages of decrease in the torque values of the specimens with silicone sealant application were significantly higher compared with both the control and chlorhexidine groups ( p = 0.001, p = 0.002, p = 0.001, and p = 0.002, respectively, according to the increasing taper angles); the percentage of decrease in torque values due to chlorhexidine application was statistically insignificant when compared with the control group. The application of gel-form chlorhexidine as an antibacterial agent does not significantly affect the stability of the implant–abutment connection under dynamic loads. PVS sealants may cause screw loosening under functional loads.

Sign in / Sign up

Export Citation Format

Share Document