Solar Engineering of Thermal Processes, Photovoltaics and Wind

2020 ◽  
Author(s):  
John A. Duffie (Deceased) ◽  
William A. Beckman ◽  
Nathan Blair
Keyword(s):  
Thermal Processes ◽  
Solar Engineering

scholarly journals Pengaruh Kolektor Pelat Gelombang Dengan Dua Kaca Penutup Terhadap Penambahan Panas Untuk Meningkatkan Kinerja Solar Water Heater

2019 ◽  
Vol 3 (2) ◽  
Author(s):  
Dian Kusuma ◽  
Mustafa . ◽  
Sudarno .
Keyword(s):  
Solar Radiation ◽  
Solar Collector ◽  
Thermal Processes ◽  
Solar Water Heater ◽  
Water Heater ◽  
Cover Glass ◽  
Solar Water ◽  
Solar Engineering ◽  
C 50 ◽  
Initial Heat

The worked principle of solar collector wave absorber plate was to transfer solar radiation to the worked fluid. The solar radiation that falls on the first glass was partially reflected, then on the second glass partially absorbed by the absorbent plate. The heat absorbed by the absorbent plate will be used to heat the worked fluid (water) between the absorbent plate and the storage plate. The purpose of this research was to design and make solar collector used wave plate with two cover glass. The addition of incomed water heat used temperatures of 30 ° C, 40 ° C, 50 ° C. The method used was used an expriment by analyzed the effect of initial heat addition on efficiency. From the results of test data obtained collector performance of solar water heater the greater the addition of heat used then the smaller the efficiency. Each of the average heat additions efficiency at 30 ° C was 19.66%, the temperature of 40 ° C was 17.75%, and the temperature of 50 ° C was 12.23%.Keywords : wave absorbent plate, added heat, solar water heaterAnonim, 2017: wibe site: unmermadiun.ac.id, tanggal 26 Agustus 2017.Anonim. Bab II Landasan Teori Prinsip Kerja Kolektor suryaPelatPenyerap. 809b5f3ff5dc603fbc474afe006faef2,Tanggal 16 Mei 2017.Anggraini, Ekadewi Handoyo, 2002: Jurnal Teknik Mesin Universitas PETRA, Surabaya.Arismunandar, W. 1995. Teknologi Rekayasa Surya. edisi pertama. PT Pradnya Paramita. Jakarta.Burhanuddin, A. 2006. Karakteristik kolektor surya pelat datar dengan variasi jarak kaca penutup dan sudut kemiringan kolektor. Skripsi. Fakultas Matematika dan Ilmu Pengetahuan Alam  Universitas Sebelas Maret, Surakarta.Beizer, 1981, Konsep Fisika Modern. Jilid 3. Terjemahan The Houw Liong Ph.D, Penerbit Erlangga, Jakarta.Culp, 1991, Prinsip-prinsip Konversi Energi, Penerbit Erlangga, Jakarta.Duffie, dan Beckman. , 1991: Solar Engineering of Thermal Processes, John Willey and Sons Inc, Wisconsin.Giancoli, 1998: Fisika edisi kelima (Terjemahan Yuhilza Hanum), Erlangga, Jakarta.Jasjfi, 1995: Perpindahan kalor, Erlangga, Jakarta.Lunde, 1980, jbptitbpp-gdl-rahadianef-30837—2008ta-2.pdf, Bab II, Teori dasar 8.Maftukhil Murot, dkk., 2016. Pengaruh Penambahan Tekanan Diatas Pelat Penyerap Terhadap Kinerja Solar Water Heater Sederhana, Widya Teknika, Vol. 24, N0. 2: 20-32.Mustofa, 2008, Studi Eksperimen Pengaruh pelat penyerap ganda model gelombang dengan penambahan reflektor terhadap kinerja Solar Water Heater sederhana, Dosen Teknik Mesin, Universitas Merdeka Madiun.Mustofa, Ismail N. R., 2013, International Jurnal of Research in Engineering and Technologi, volume.02, Issue.09, September 2013.Prijono, 1986, Prinsip-prinsip Perpindahan Panas, Penerbit Erlangga, Jakarta.Rahadian, 2008 : Jurnal Teknik Mesin Universitas Sumatra Utara.Sijabat, Andri M. 2014. Rancang Bangun dan Analisa Kolektor Surya Tipe Pelat Datar Bersirip Untuk Penghasil Panas Pada Pengering Hasil Pertanian dan Perkebunan. Skripsi. Fakultas Teknik Universitas Sumatra Utara, Medan.Subur Edi S., Irfan Santoso. 2014. Jurnal Teknologi: Perancangan Solar Water Heater Jenis Pelat Datar Temperatur Medium Untuk Aplikasi Penghangat Air Mandi. Volume 7 Nomor 2: 118-127.Tirtoatmodjo, R., Ekadewi, A. H, 1999: Jurnal Teknik Mesin Universitas Kristen Petra

Solar Engineering of Thermal Processes

1985 ◽  
Vol 53 (4) ◽  
pp. 382-382 ◽  
Author(s):  
John A. Duffie ◽  
William A. Beckman ◽  
Jon McGowan
Keyword(s):  
Thermal Processes ◽  
Solar Engineering

scholarly journals Solar Engineering of Thermal Processes, 2nd ed.

1994 ◽  
Vol 116 (1) ◽  
pp. 67-68 ◽  
Author(s):  
J. A. Duffie ◽  
William A. Beckman ◽  
W. M. Worek
Keyword(s):  
Thermal Processes ◽  
Solar Engineering

Solar Engineering of Thermal Processes

2013 ◽  
Author(s):  
John A. Duffie ◽  
William A. Beckman
Keyword(s):  
Thermal Processes ◽  
Solar Engineering

Solar Engineering of Thermal Processes, second edition

Solar Energy ◽  
1993 ◽  
Vol 51 (6) ◽  
pp. 521
Author(s):  
A.B. Schaap ◽  
W.B. Veltkamp
Keyword(s):  
Thermal Processes ◽  
Solar Engineering

Research and Modelling on Electrical and Thermal Mode of LEDs Operation in the Luminaire

2018 ◽  
pp. 155-162 ◽  
Author(s):  
Sergei S. Kapitonov ◽  
Anastasia V. Kapitonova ◽  
Sergei Yu. Grigorovich ◽  
Sergei A. Medvedev ◽  
Taher Sobhy
Keyword(s):  
Thermal Conditions ◽  
Operating Mode ◽  
Thermal Processes ◽  
Thermal Mode ◽  
Crystal Temperature ◽  
Premature Failure ◽  
Model Based

In the article, the electrical and thermal processes in the LED lamp with varied parameters are investigated. Voltage and current measurements on all LEDs of the luminaire are carried out in the nominal operating mode. The power allocated to each LED is determined. The calculation of the LED crystal temperature was carried out using the developed thermal LED model based on the results of the measurements and by using “Multisim” program. It has been established that the temperature of the crystals of individual LEDs in the luminaire differ significantly, which leads to unfavourable thermal conditions for them and an increased likelihood of premature failure.

INFLUENCE OF HEAT TREATMENT OF MOUNTAIN MASSIVE ON TEMPERATURE MODE OF GEOTHERMAL CIRCULATION SYSTEM

2018 ◽  
pp. 44-50
Author(s):  
Yu. P. Morozov
Keyword(s):  
Heat Transfer ◽  
Operating Time ◽  
Fluid Motion ◽  
Coolant Temperature ◽  
Circulation System ◽  
Thermal Processes ◽  
Temperature Mode ◽  
Heat Influx ◽  
Stationary Heat Transfer

Based on the solution of the problem of non-stationary heat transfer during fluid motion in underground permeable layers, dependence was obtained to determine the operating time of the geothermal circulation system in the regime of constant and falling temperatures. It has been established that for a thickness of the layer H <4 m, the influence of heat influxes at = 0.99 and = 0.5 is practically the same, but for a thickness of the layer H> 5 m, the influence of heat inflows depends significantly on temperature. At a thickness of the permeable formation H> 20 m, the heat transfer at = 0.99 has virtually no effect on the thermal processes in the permeable formation, but at = 0.5 the heat influx, depending on the speed of movement, can be from 50 to 90%. Only at H> 50 m, the effect of heat influx significantly decreases and amounts, depending on the filtration rate, from 50 to 10%. The thermal effect of the rock mass with its thickness of more than 10 m, the distance between the discharge circuit and operation, as well as the speed of the coolant have almost no effect on the determination of the operating time of the GCS in constant temperature mode. During operation of the GCS at a dimensionless coolant temperature = 0.5, the velocity of the coolant is significant. With an increase in the speed of the coolant in two times, the error changes by 1.5 times.

Sign in / Sign up

Export Citation Format

Share Document