Numerical and experimental investigation of parabolic trough collector with focal evacuated tube and different working fluids integrated with single slope solar still

Heat Transfer ◽  
2020 ◽  
Author(s):  
Tamer Nabil ◽  
Mohamed M. K. Dawood
Author(s):  
Jamasb Pirkandi ◽  
Farshid Kassaei ◽  
Mahdi Hashemabadi

Abstract In this research, the performance of stepped solar still has been experimentally evaluated. For this purpose, a parabolic trough collector has been used to preheat the saline water entering the solar still. Also, two flat external reflectors have been employed to increase the amount of solar energy received by the steps and the collector of the system. The findings of this research indicate that the use of two flat external reflectors is more effective than using the trough collector. Also, it is more efficient to apply both mechanisms simultaneously than to use them separately. According to the obtained results, the distilled water output of the solar still is 760, 1,560, 2,440 and 2,760 ml/m2, respectively, for operating the conventional solar still, using the trough collector, using the two flat external reflectors, and using the collector and reflectors simultaneously. The electrical conductivity due to the presence of salt and chemical substances dissolved in the distilled water discharged from the still is 255, 215, 62 and 38 micro Siemens per centimetre, respectively, for each of the four mentioned cases. These experiments show that by applying the proposed mechanisms, the amount of distilled water can be increased, and its purity can be enhanced.


2015 ◽  
Vol 46 (4) ◽  
pp. 347-368 ◽  
Author(s):  
Cheng Li ◽  
T. Yan ◽  
Ruzhu Wang ◽  
Liwei Wang ◽  
T. X. Li ◽  
...  

2019 ◽  
Vol 111 ◽  
pp. 01054 ◽  
Author(s):  
F. Mertkan Arslan ◽  
Hüseyin Günerhan

In this study energetic and exergetic performances of parabolic trough collector is theoretically investigated by using 120 l/min synthetic ‘’Dowtherm A’’ oil , 1200 l/min Air at 100 bar (10 MPa) and 150 l/min molten salt which is mixture of 60 wt% sodium nitrate (NaNO3) and 40 wt% potassium nitrate (KNO3) which are widely used as heat transfer fluids. Fluids performance comparisons were performed with the LS-2 module, which is used with vacuum in annulus and Cermet as a selective coating. LS-2 module has 7.8 m receiver length and is 39 m2 aperture area. As a result, the maximum exergy efficiency of the molten salt, synthetic oil, Air to be 41.19% at 422 °C, 40.82% at 400 °C, 40.33% at 402 °C, respectively. The maximum exergy of air is higher than other working fluids up to 310 ° C but after about 310 ° C the exergy of the molten salt is higher than the others. The molten salt has the best energy efficiency at its operating temperatures (250 °C to 550 °C) than other working fluids.


Sign in / Sign up

Export Citation Format

Share Document