Specification and Stability Tests versus Jackknifing: Some Illustrative Examples

1989 ◽  
pp. 37-43
Author(s):  
Bernd Schips ◽  
Yngve Abrahamsen
Keyword(s):  
Stability Tests

Oscillator stability tests on board armored vehicles

2004 ◽  
Author(s):  
H. Heikkila ◽  
P. Eskelinen ◽  
J. Ruoskanen ◽  
J. Peltonen ◽  
A. Serkola ◽  
...  
Keyword(s):  
Stability Tests ◽  
Armored Vehicles ◽  
Oscillator Stability

Designing of Outriggers for the Needs of the Vehicles Stability Testing

2018 ◽  
Vol 875 ◽  
pp. 71-76
Author(s):  
Victor Kryaskov ◽  
Andrey Vashurin ◽  
Anton Tumasov ◽  
Alexey Vasiliev
Keyword(s):  
Coefficient Of Friction ◽  
Computer Aided Design ◽  
Strength Analysis ◽  
Direct Impact ◽  
Stability Testing ◽  
Supporting Surface ◽  
Stability Tests ◽  
Computer Aided ◽  
Aided Design

This paper is dedicated to the issues of designing of outriggers for avoidance of vehicle tilting during its stability tests. An analysis of existing types of outriggers was done by authors as well as legislative requirements on them. The reliable and well-timed operation of outriggers largely depends on the height of their positioning on a vehicle. In order to determine this important parameter a special methodic of determining the tipping angle of the vehicle with the use of computer-aided design (CAD) was composed by authors. The article also contains some main principles of strength analysis of the structure a very important part of which became the necessity of determination of coefficient of friction between the outrigger sliders and the supporting surface. This coefficient has a direct impact on the value of transverse forces appearing at the ends of outrigger beams.

Stability tests of electronic calibration units

2014 ◽  
Author(s):  
M. Zeier ◽  
J. Hoffmann ◽  
P. Hurlimann ◽  
J. Rufenacht ◽  
M. Wollensack ◽  
...  
Keyword(s):  
Stability Tests

scholarly journals Stability tests of the Westinghouse coil in the International Fusion Superconducting Magnet Test Facility

1988 ◽  
Vol 24 (2) ◽  
pp. 779-782 ◽  
Author(s):  
L. Dresner ◽  
D.T. Fehling ◽  
M.S. Lubell ◽  
J.W. Lue ◽  
J.N. Luton ◽  
...  
Keyword(s):  
Superconducting Magnet ◽  
Test Facility ◽  
Stability Tests

scholarly journals The Effect of Formulation, Dose, and Adjuvants on Uptake of Phosphite Into Pine Foliage

Plant Disease ◽  
2017 ◽  
Vol 101 (9) ◽  
pp. 1652-1658 ◽  
Author(s):  
Carol A. Rolando ◽  
Robyn E. Gaskin ◽  
Stefan F. Gous ◽  
David B. Horgan ◽  
Laura G. Raymond
Keyword(s):  
Nmr Spectroscopy ◽  
Pinus Radiata ◽  
Seed Oil ◽  
Alcohol Ethoxylate ◽  
Oil Uptake ◽  
Stability Tests ◽  
Dose Concentration

The aim of this investigation was to determine the effect of dose and adjuvant on uptake of two phosphite products (Phos-A and Phos-B) into Pinus radiata needles. In experiment 1, uptake of 6 kg ha−1 phosphite, applied as Phos-A, in 100 liters of water, together with an organosilicone superspreader (0.2%), was high (>60%). Uptake at doses greater than 6 kg ha−1 (12, 15, 18, and 24 kg ha−1) and applied in volumes less than 100 liters of water (75 and 50 liters) was poor (1 to 30%). Using stability tests and NMR spectroscopy in experiment 2, this appeared to be linked to a concentration dependent reaction resulting in the degradation of the organosilicone adjuvant that facilitated uptake of Phos-A. In experiment 3, uptake of phosphite applied as Phos-B, between 6 and 24 kg ha−1 in 100 liters of water, was tested alone and with four adjuvants (an organosilicone, alcohol ethoxylate, lecithin, and esterified seed oil). Uptake of Phos-B without any adjuvant was high (>50%) across all doses, indicating the formulation was optimized for P. radiata needles. Uptake of Phos-B increased with concentration up to 72% at 24 kg ha−1 in 100 liters of water. Symptoms of phytotoxicity were observed at rates of ≥12 kg ha−1. This study highlighted the effect of formulation, dose, concentration, and adjuvant on the uptake of phosphite into P. radiata needles.

Sign in / Sign up

Export Citation Format

Share Document