General Electric Company is developing and testing low heating value fuel gas turbine combustors for use in integrated gasification combined cycle power generation systems. This paper presents the results of a series of combustion tests conducted at the pilot scale coal gasification and high temperature desulfurization system located at GE Corporate Research and Development in Schenectady, New York. Tests were performed in a modified GE MS6000 combustor liner operating at a pressure of 10 bar and over a wide load range (combustor exit temperatures from 760 to 1400°C).
The primary objective of these tests was to compare and contrast the performance (emissions, flame stability, and combustor liner temperatures) of six different low heating value fuel nozzle designs, representing three distinct nozzle concepts. With 2200 to 4600 ppmv NH3 in the fuel, the conversion of fuel NH3 to NOx was roughly independent of fuel nozzle type, and ranged from about 70% at low combustor exit temperatures to about 20% at high combustor exit temperatures. For all of the fuel nozzles, CO emissions were typically less than 5 ppmv (on a dry, 15% O2 basis) at combustor exit temperatures greater than 980°C. Significant differences in CO emissions were observed at lower combustor exit temperatures. Some differences in liner temperatures and flame stability were also observed with the different nozzles. In general, nozzles which produced lower CO emissions and greater flame stability had higher fuel swirl angles and resulted in higher combustor liner temperatures. The nozzle with the best overall performance (consisting of concentric axial air and fuel swirlers and an air cooled mixing cup) has been selected for use at a commercial site.
Liquid Ammonia Spray Combustion in Two-Stage Micro Gas Turbine Combustors at 0.25 MPa; Relevance of Combustion Enhancement to Flame Stability and NOx Control