scholarly journals Degradation and Stabilization of Poly(Butylene Adipate-co-Terephthalate)/Polyhydroxyalkanoate Biodegradable Mulch Films Under Different Aging Tests

Author(s):  
James H. Wang ◽  
Yuchuan Tian ◽  
Bing Zhou
Chemosphere ◽  
2008 ◽  
Vol 71 (9) ◽  
pp. 1607-1616 ◽  
Author(s):  
Thitisilp Kijchavengkul ◽  
Rafael Auras ◽  
Maria Rubino ◽  
Mathieu Ngouajio ◽  
R. Thomas Fernandez

Chemosphere ◽  
2020 ◽  
Vol 256 ◽  
pp. 126985 ◽  
Author(s):  
Patrícia Moraes Sinohara Souza ◽  
Lais Roberta Deroldo Sommaggio ◽  
Maria Aparecida Marin-Morales ◽  
Ana Rita Morales

2019 ◽  
pp. 47-50
Author(s):  
H. Wenqing ◽  
L. Zhen ◽  
Y. Changrong ◽  
H. Xin ◽  
L. Qi ◽  
...  

2017 ◽  
Vol 873 ◽  
pp. 117-122
Author(s):  
Tarinee Nampitch ◽  
Thiti Kaisone ◽  
Pran Hanthanon ◽  
Chanon Wiphanurat ◽  
Sumate Ouipanich ◽  
...  

The present research aimed to develop biodegradable mulch films that could resolve the environmental problem in agriculture. The research also compared the properties of transparent and black commercial mulch films. Blended films were prepared by blown-film extrusion, heating at 170 °C, and rotation at 55 rpm. The results revealed that the appearance of FTIR spectra were shown as functional groups of PBAT, described at 1710 cm-1 and 1267 cm-1, which corresponds to carbonyl groups in ester linkage and C-O in ester linkage, respectively. The presence of O-H carboxylic acids, attributed within the range 910-950 cm-1. The films containing 10% PLA loading showed peaks from 937 to 1712 cm-1, more than films containing 20% PLA loading. The carbon black contained in the biodegradable film could interrupt the mobility of the polymer chain, leading to decreased Tm, while the incorporation of carbon black in biodegradable mulch films could increase the tensile properties of blends.


2017 ◽  
Vol 26 (6) ◽  
pp. 2588-2600 ◽  
Author(s):  
François Touchaleaume ◽  
Hélène Angellier-Coussy ◽  
Guy César ◽  
Grégory Raffard ◽  
Nathalie Gontard ◽  
...  

Water ◽  
2019 ◽  
Vol 11 (9) ◽  
pp. 1819
Author(s):  
Lu Deng ◽  
Xianyong Meng ◽  
Ruide Yu ◽  
Qian Wang

Plastic mulch film is widely used in agricultural production. However, there are very few studies on degradable mulch film. In order to investigate the effects of using degradable mulch film in arid regions on crop yield and water use efficiency, we used fully biodegradable mulch films on both maize and bare land cultivation experimental areas. The DeNitrification-DeComposition (DNDC) model was used to analyze changes in maize biomass in the future under different climate scenario models. We found that using fully biodegradable mulch film in an arid region had a positive effect on biomass yields. In 2015–2017, the annual maize biomass yield increased by 24.5%, 28.9%, and 32.9%, respectively. Hence, this method has expansion and promotion value. A comparison of the DNDC model simulated biomass yields and actual measured values found that the ranges of R2, root mean square error (RMSE), and model efficiency (ME) were 0.98–0.99, 0.38–0.86 mg C ha−1, and 0.80–0.98. This result shows that the DNDC model can accurately simulate changes in maize biomass in this region. Under the premise of a good model fit, future climate scenario model data were used to drive the DNDC model. The results showed that the possible range of maize biomass yields in the future is −6.5% to 10.3%, with the most probable range being 0.2–1.5%. Using future climatic conditions, our work suggests that degradable mulch films can increase water use efficiency by an average of 9.5%. The results of this study can be used to promote the use of degradable mulch films in arid regions, significantly improving sustainable agricultural development.


2010 ◽  
Vol 29 (4) ◽  
pp. 471-476 ◽  
Author(s):  
Ana Paula Bilck ◽  
Maria V.E. Grossmann ◽  
Fabio Yamashita

Sign in / Sign up

Export Citation Format

Share Document