scholarly journals Experimental evaluation of an internal heat exchanger in a CO2 subcritical refrigeration cycle with gas-cooler

2015 ◽  
Vol 80 ◽  
pp. 31-41 ◽  
Author(s):  
Rodrigo Llopis ◽  
Carlos Sanz-Kock ◽  
Ramón Cabello ◽  
Daniel Sánchez ◽  
Enrique Torrella
2013 ◽  
Vol 21 (01) ◽  
pp. 1350005 ◽  
Author(s):  
Z. WANG ◽  
Y. GONG ◽  
X. H. WU ◽  
W. H. ZHANG ◽  
Y. L. LU

This work presents the experimental evaluation of the energy performance of transcritical CO2 refrigeration and heat pump systems. The optimal gas cooler pressures and the optimal COP have been analyzed from a thermodynamic point of view. The systems used a new dual expansion valve and a balance CO2 liquid receiver adjustment device, which can control high and low side pressure effectively. Moreover, we demonstrate the influence of the internal heat exchanger (IHX) on the systems' performances, on the basis of the analysis of the relative COP index RCOPI, the compressor power index RPCI and other parameters which can confirm the truth of. The experimental evaluation covers five evaporating levels (-10 to 10°C) and in a wide range of gas cooler pressures (75 to 120 bar). It is concluded that with the IHX system, compressor power is relatively low when the high side pressure is over 100 bar, and the evaporation temperature is below 0°C. The COP of the system without the IHX is slightly higher than the system with the IHX; it is increasing about 3% to 5%, when the evaporation temperature is over 5°C. Relative to the single expansion process, the dual expansion cycle can decrease the influence of pressure fluctuations of CO2 supercritical fluid and liquid mixture on the systems.


2021 ◽  
Vol 11 (13) ◽  
pp. 6226
Author(s):  
Morteza Ghanbarpour ◽  
Adrián Mota-Babiloni ◽  
Bassam E. Badran ◽  
Rahmatollah Khodabandeh

The phase-down of hydrofluorocarbons and substitution with low global warming potential values are consequences of the awareness about the environmental impacts of greenhouse gases. This theoretical study evaluated the energy and exergy performances and the environmental impact of three vapor compression system configurations operating with the hydrocarbons R290, R600a, and R1270 as alternatives to R134a. The refrigeration cycle configurations investigated in this study include a single-stage cycle, a cycle equipped with an internal heat exchanger, and a two-stage cycle with vapor injection. According to the results, the alternative hydrocarbon refrigerants could provide comparable system performance to R134a. The analysis results also revealed that using an internal heat exchanger or a flash tank vapor injection could improve the system’s efficiency while decreasing the heating capacity. The most efficient configuration was the two-stage refrigeration cycle with vapor injection, as revealed by the exergy analysis. The environmental impact analysis indicated that the utilization of environmentally-friendly refrigerants and improving the refrigeration system’s efficiency could mitigate equivalent CO2 emissions significantly. The utilization of hydrocarbons reduced the carbon footprint by 50%, while a 1% to 8% reduction could be achieved using the internal heat exchanger and flash tank vapor injection.


Author(s):  
Adriana Greco ◽  
Ciro Aprea ◽  
Angelo Maiorino

Carbon dioxide (R744) is as a valid alternative to classical substances such as HFCs used in vapour compression plants. A transcritical refrigeration cycle is needed because the critical temperature of carbon dioxide is usually lower than the ambient temperature. In this chapter the performances of a transcritical cycle have been evaluated with a prototype R744 system working as a classical spit-systems to cool air. An experimental analysis has been carried out on the effect of: refrigerant charge, internal heat exchanger, heat rejection pressure on the energetic performances of the transcritical plant. An experimental analysis of a hybrid trans-critical refrigerator-desiccant wheel system has been carried out in order to improve the COP. The experimental transcritical cycle has been examined in comparison with a classical vapour compression plant working with the R134a.


Sign in / Sign up

Export Citation Format

Share Document