Arthroscopic knot tying: The role of instrumentation in achieving knot security

Author(s):  
Marc J. Milia ◽  
Richard D. Peindl ◽  
Patrick M. Connor
2019 ◽  
Vol 10 (2) ◽  
pp. 35-39
Author(s):  
Alexander CM. Chong ◽  
Daniel J. Prohaska ◽  
Brian P. Bye

Introduction. With arthroscopic techniques being used, the importanceof knot tying has been examined. Previous literaturehas examined the use of reversing half-hitches on alternatingposts (RHAPs) on knot security. Separately, there has been researchregarding different suture materials commonly used inthe operating room. The specific aim of this study was to validatethe effect of different stacked half-hitch configuration anddifferent braided suture materials on arthroscopic knot integrity. Methods. Three different suture materials tied withfive different RHAPs in arthroscopic knots were compared.A single load-to-failure test was performed andthe mean ultimate clinical failure load was obtained. Results. Significant knot holding strength improvement wasfound when one half-hitch was reversed as compared to baselineknot. When two of the half-hitches were reversed, therewas a greater improvement with all knots having a mean ultimateclinical failure load greater than 150 newtons (N). Comparisonof the suture materials demonstrated a higher meanultimate clinical failure load when Force Fiber® was used andat least one half-hitch was reversed. Knots tied with eitherForce Fiber® or Orthocord® showed 0% chance of knot slippagewhile knots tied with FiberWire® or braided fishing linehad about 10 and 30% knot slippage chances, respectively. Conclusion. A significant effect was observed in regards to bothstacked half-hitch configuration and suture materials used onknot loop and knot security. Caution should be used with tyingthree RHAPs in arthroscopic surgery, particularly witha standard knot pusher and arthroscopic cannulas. The findingsof this study indicated the importance of three RHAPsin performing arthroscopic knot tying and provided evidenceregarding discrepancies of maximum clinical failure loads observedbetween orthopaedic surgeons, thereby leading to bettersurgical outcomes in the future. KS J Med 2017;10(2):35-39.


2021 ◽  
Vol 0 ◽  
pp. 1-2
Author(s):  
B. H. Banarji ◽  
A. Vinoth

Arthroscopic knot tying is a crucial component for a successful arthroscopic shoulder surgery. Knot tying should not be difficult to master or time consuming to perform. This study describes a new sliding locking knot for arthroscopic shoulder surgery and we named it Banarji knot, in the name of the author. It is a low profile, non-bulky, and double locking knot, which makes it a more secure knot.


2008 ◽  
Vol 36 (12) ◽  
pp. 2407-2414 ◽  
Author(s):  
Omer A. Ilahi ◽  
Shiraz A. Younas ◽  
David M. Ho ◽  
Phillip C. Noble

Background The security of several popular arthroscopic knots to prolonged, incremental, cyclic loads is unknown, as is the security of knots tied with newer, superstrong sutures. Hypothesis Some arthroscopic knots are as secure as openly tied square knots, and knots tied with superstrong sutures are more secure than those tied with braided polyester. Some arthroscopic knots are significantly bulkier than openly tied square knots. Study Design Controlled laboratory study. Methods Five types of openly tied knots (3-throw square, 4-throw square, 5-throw square, 5-throw slip, open SAK [simple arthroscopic knot]), 6 complex arthroscopic knots backed with 3 reversed half-hitches with alternating posts (RHAPs) (SMC, Weston, taut-line hitch, Tennessee slider, Roeder, Duncan loop), and 2 stacked half-hitch (SHH) arthroscopic knots (surgeon's [S=S=S//xS//xS//xS], SAK [S=S//xSxS//xS]) were tied using No. 2 Ethibond around 2 aluminum rods, which were pulled apart with stepwise, incremental, cyclic loads to a maximum force of 120 N (2250 total cycles). Then, 5-throw square knots openly tied with No. 2 Fiberwire, Orthocord, or Ultrabraid were subjected to the stepwise, incremental, cyclic loading protocol extended to a 260-N load level. Before mechanical testing, the height (maximum diameter) of each knot was measured with digital calipers. Results For Ethibond, the openly tied 3-throw square knots (56.2 ± 21.4 N) and 5-throw slip knots (49.9 ± 26.9 N) reached clinical failure (3 mm of laxity) at significantly lower loads ( P < .05) than openly tied 5-throw square knots (90.8 ± 6.5 N), whereas the openly tied SAK (82.3 ± 9.4 N) and 4-throw square (84.3 ± 11.6 N) and all arthroscopically tied knots reached 3 mm of laxity at statistically similar loads. Five-throw square knots openly tied with Fiberwire or Orthocord reached 3 mm of laxity at much higher loads (194.9 ± 28.4 N and 168.4 ± 8.6 N, respectively) than those tied using Ethibond (P < .001 for each comparison), but there was no significant difference in performance between Fiberwire knots and Orthocord knots. Although Ultrabraid square knots also were stronger than those tied with Ethibond (137.9 ± 15.9 N, P < .005), they were not as secure as those tied with Orthocord or Fiberwire (P < .05). Compared with the 5-throw square knots, all arthroscopic knots were significantly bulkier. Especially bulky knots were the Duncan loop and the taut-line hitch. Orthocord square knots demonstrated bulkiness similar to Ethibond square knots, whereas Fiberwire and Ultrabraid square knots were significantly bulkier. Conclusions For braided suture, 5-throw knots optimize square knot security. Open or arthroscopic slip knots can achieve similar security with post switching and loop reversal. Fiberwire, Orthocord, or Ultrabraid openly tied square knots offer greater security than those tied with Ethibond. Arthroscopic knots vary in their bulkiness, but all are significantly bulkier than 5-throw openly tied square knots. Square knots openly tied with Fiberwire or Ultrabraid tend to be bulkier than if tied with Ethibond or Orthocord, which are similar to each other. Clinical Relevance The 5-throw openly tied square knot remains the gold standard, although the openly tied SAK offers similar security when tying in a hole. Arthroscopic knots, whether complex knots backed up by 3 RHAPs, the 6-throw surgeon's knot, or the 5-throw SAK, give security similar to the standard. Square knots tied with the newer sutures in open fashion are more secure than if tied with braided polyester. Using lower profile knots may be especially important when employing Fiberwire or Ultrabraid, as these sutures tend to result in bulkier knots than those tied with Ethibond or Orthocord.


1999 ◽  
Vol 15 (5) ◽  
pp. 515-521 ◽  
Author(s):  
Wesley M. Nottage ◽  
Robert K. Lieurance
Keyword(s):  

2004 ◽  
pp. 29-38
Author(s):  
Frank G. Alberta ◽  
Augustus D. Mazzocca ◽  
Brian J. Cole ◽  
Anthony A. Romeo
Keyword(s):  

2004 ◽  
Vol 12 (4) ◽  
pp. 240-244 ◽  
Author(s):  
J. Clinton Walker ◽  
Keith M. Baumgarten ◽  
Rick W. Wright
Keyword(s):  

Sign in / Sign up

Export Citation Format

Share Document