Multifunctional solar bamboo straw: Multiscale 3D membrane for self-sustained solar-thermal water desalination and purification and thermoelectric waste heat recovery and storage

Carbon ◽  
2021 ◽  
Vol 171 ◽  
pp. 359-367
Author(s):  
Biyao Gong ◽  
Huachao Yang ◽  
Shenghao Wu ◽  
Yikuan Tian ◽  
Xinzheng Guo ◽  
...  
Keyword(s):  
Heat Recovery ◽  
Waste Heat Recovery ◽  
Thermal Water ◽  
Waste Heat ◽  
Water Desalination ◽  
Solar Thermal ◽  
And Storage

scholarly journals Design and Analysis of Biomass Drying unit with Waste Heat Recovery and Storage

2012 ◽  
Vol 38 ◽  
pp. 1161-1165
Author(s):  
M. Gowtham ◽  
Amrit om nayak ◽  
T. Manoj ◽  
G. Ram Kumar
Keyword(s):  
Heat Recovery ◽  
Waste Heat Recovery ◽  
Waste Heat ◽  
And Storage

Optimal Design of Water Desalination Systems Involving Waste Heat Recovery

2017 ◽  
Vol 56 (7) ◽  
pp. 1834-1847 ◽  
Author(s):  
Ramón González-Bravo ◽  
José María Ponce-Ortega ◽  
Mahmoud M. El-Halwagi
Keyword(s):  
Optimal Design ◽  
Heat Recovery ◽  
Waste Heat Recovery ◽  
Waste Heat ◽  
Water Desalination

scholarly journals Comparative Study of Conventional and Water Circulating-Heat Sink Cooling Base Thermoelectric Generator System for Optimum Solar Thermal Waste Heat Recovery

2021 ◽  
Vol 25 (4) ◽  
pp. 503-509
Author(s):  
A. Yusuf ◽  
M.H. Ali
Keyword(s):  
Power Generation ◽  
Heat Sink ◽  
Heat Recovery ◽  
Waste Heat Recovery ◽  
Waste Heat ◽  
Thermal Power ◽  
Solar Thermal ◽  
Circulating Water ◽  
Solar Thermal Power ◽  
Solar Thermal Power Generation

A novel technique for waste heat recovery in solar thermal power generation is investigated through experimentation and  systematically presented. Power generation using Thermoelectric Generator (TEG) is a promising technique in waste heat recovery application. In this topology, TEG array is directly attached to the back of the solar Photovoltaic panel (model AP-AM15) to receive the transmitted heat at the back of the PV panel as waste heat. More so, a circulating water-heat sink is attached to the TEG cold side to improve the temperature gradient. Base on Seebeck effect, the TEG directly converts the temperature difference into electricity. The experimental result shows that efficiency between the range of 2.1% and 4.7% for the conventional cooling system while the output power approximately ranges between 0.05W and 0.47W, the circulating water-heat sink technique has efficiency ranging between 2.9% and 10.3% with output power between the range of 0.10W and 2.2W. The daily average increase in efficiency was found to be 263.76%. This shows that the daily average power is improved by a factor of 2.6376 with the water circulating water-heat sink technique. This is an indication of waste heat recovery from the solar thermal power generation.

Recovery, Utilization and Research of Waste Heat from the Blast Furnace Water Granulated Slag

2012 ◽  
Vol 512-515 ◽  
pp. 1205-1211 ◽  
Author(s):  
Fang Ming Wang ◽  
Xue Song Li ◽  
Yang Wang
Keyword(s):  
Power Generation ◽  
Blast Furnace ◽  
Blast Furnace Slag ◽  
Heat Recovery ◽  
Waste Heat Recovery ◽  
Sea Water ◽  
Waste Heat ◽  
Water Desalination ◽  
Granulated Slag ◽  
Furnace Slag

To make use of waste heat of water quenching for blast furnace slag in production, this paper introduces and then analyzes some ways of waste heat recovery is used to power generation, sea water desalination and heating, in particular, indicates that the form of indirect heating of graining tower steam recycling equipment is the best most application and extension.

Sign in / Sign up

Export Citation Format

Share Document