Subcooled flow boiling heat transfer of water in a circular tube under high heat fluxes and high mass fluxes

2015 ◽  
Vol 100 ◽  
pp. 406-418 ◽  
Author(s):  
Jianguo Yan ◽  
Qincheng Bi ◽  
Zhaohui Liu ◽  
Ge Zhu ◽  
Laizhong Cai
2017 ◽  
Vol 139 (11) ◽  
Author(s):  
X. Yu ◽  
C. Woodcock ◽  
Y. Wang ◽  
J. Plawsky ◽  
Y. Peles

An experimental study on subcooled flow boiling with engineering fluid HFE-7000 in a microchannel fitted with piranha pin fins (PPFs) is presented. Heat fluxes of up to 735 W/cm2 were achieved and mass fluxes ranged from 618 kg/m2s to 2569 kg/m2 s. It was found that the flow boiling heat transfer was significantly enhanced with PPFs. The heat transfer coefficient with flow boiling was double the corresponding single-phase flow. Correlations for two-phase heat transfer coefficient and pressure drop in the nucleate flow boiling regime were developed based on the boiling, Weber, and Jakob numbers. The onset of nucleate boiling (ONB) and the critical heat flux (CHF) conditions were determined through visualization and was typically initiated from the last row of fins where temperatures were highest and flow rates lowest.


Author(s):  
Guodong Wang

In this paper, a simultaneous visualization and measurement study have been carried out to investigate bubble nucleation frequency of water in micro-channel at various heat fluxes and mass fluxes. A single micro-channel with an identical rectangular cross-section having a hydraulic of 137 μm and a heating length of 30 mm was used in this experiment. It is shown that the frequency of bubble nucleation increased drastically with the increase of heat flux and was also strongly dependent on the mass flux. A dimensionless frequency of bubble nucleation was correlated in terms of the Boiling number. The predictions of bubble nucleation frequency in the microchannel are found in good agreement with experimental data with a MAE of 10.4%.


Sign in / Sign up

Export Citation Format

Share Document