Assessment of RANS turbulence models for numerical study of laminar-turbulent transition in convection heat transfer

Author(s):  
M. Abdollahzadeh ◽  
M. Esmaeilpour ◽  
R. Vizinho ◽  
A. Younesi ◽  
J.C. Pàscoa
Author(s):  
Povilas Poskas ◽  
Robertas Poskas ◽  
Giedrius Drumstas

In this paper we present the results on experimental and numerical investigations of the local opposing mixed convection heat transfer in an inclined flat channel (φ = 60° from horizontal position) with symmetrical heating in the laminar-turbulent transition region. The experiments were performed in airflow (p = 0.2 and 0.4 MPa) in the range of Re from 1.5 · 103 to 5.3 · 104 and Grq up to 1.5 · 1010 and at the limiting condition qw1 ≈ qw2 ≈ const. The experimental data show similar tendencies in the heat transfer as it was revealed in vertical channel. It is already some difference in the local heat transfer for upper (stable density stratification) and bottom (unstable density stratification) walls. The data of the experimental investigations have been compared with the results of numerical modelling using Ansys Fluent 12.0 code. The modelling was performed using laminar and transition models for Rein = 3.1 · 103 and Grqin = 1.9 · 109 for the same conditions as during the experiment, i.e. with the same airflow pressure (0.4 MPa), velocity, and temperature at the inlet and heat flux at the walls of the flat channel with the same geometrical characteristics.


Author(s):  
Chen-Ru Zhao ◽  
Zhen Zhang ◽  
Qian-Feng Liu ◽  
Han-Liang Bo ◽  
Pei-Xue Jiang

Numerical investigations are performed on the convection heat transfer of supercritical pressure fluid flowing through vertical mini tube with inner diameter of 0.27 mm and inlet Reynolds number of 1900 under various heat fluxes conditions using low Reynolds number k-ε turbulence models due to LB (Lam and Bremhorst), LS (Launder and Sharma) and V2F (v2-f). The predictions are compared with the corresponding experimentally measured values. The prediction ability of various low Reynolds number k-ε turbulence models under deteriorated heat transfer conditions induced by combinations of buoyancy and flow acceleration effects are evaluated. Results show that all the three models give fairly good predictions of local wall temperature variations in conditions with relatively high inlet Reynolds number. For cases with relatively low inlet Reynolds number, V2F model is able to capture the general trends of deteriorated heat transfer when the heat flux is relatively low. However, the LS and V2F models exaggerate the flow acceleration effect when the heat flux increases, while the LB model produces qualitative predictions, but further improvements are still needed for quantitative prediction. Based on the detailed flow and heat transfer information generated by simulation, a better understanding of the mechanism of heat transfer deterioration is obtained. Results show that the redistribution of flow field induced by the buoyancy and flow acceleration effects are main factors leading to the heat transfer deterioration.


Sign in / Sign up

Export Citation Format

Share Document