scholarly journals Influence of process parameters on deep drawing of 2060 Al–Li alloy under hot stamping process

2020 ◽  
Vol 3 (1) ◽  
pp. 36-42
Author(s):  
Xiaoming Yang ◽  
Baoyu Wang ◽  
Jing Zhou ◽  
Liming Dang ◽  
Wenchao Xiao ◽  
...  
Keyword(s):  
Process Parameters ◽  
Deep Drawing ◽  
Hot Stamping ◽  
Influence Of Process Parameters ◽  
Stamping Process

Interlaboratory Comparison of Friction Conditions in Hot Stamping Operations

2010 ◽  
Vol 438 ◽  
pp. 97-105 ◽  
Author(s):  
Francesca Borsetto ◽  
Andrea Ghiotti ◽  
Stefania Bruschi ◽  
T. Stoehr ◽  
J. Lechler ◽  
...  
Keyword(s):  
Friction Coefficient ◽  
Process Parameters ◽  
Interlaboratory Comparison ◽  
Hot Stamping ◽  
Testing Procedures ◽  
Analysis Tools ◽  
Stamping Process

The paper presents results obtained at two labs, on in Germany and one in Italy, in terms of friction coefficient as function of hot stamping process parameters. Even if the testing procedures and analysis tools to evaluate tribological conditions are different for the two labs, both the approaches show a similar trend as regards the friction coefficient dependence from the process parameters.

Influence of Process Parameters on Limiting Drawing Ratio of IS513 CR3 Grade Steel Sheet during Warm Deep Drawing

2014 ◽  
Vol 984-985 ◽  
pp. 62-66 ◽  
Author(s):  
T. Mayavan ◽  
Loganathan Karthikeyan
Keyword(s):  
Process Parameters ◽  
Deep Drawing ◽  
Steel Sheet ◽  
Experimental Results ◽  
Drawing Ratio ◽  
Influence Of Process Parameters ◽  
Steel Sheets ◽  
Limiting Drawing Ratio ◽  
Warm Deep Drawing ◽  
Grade Steel

In this work the significance of important parameters such as Blank temperature, Blank hold force on limiting drawing ratio (LDR) of IS513 CR3 steel sheets during warm deep drawing was determined. Influence of these parameters was analyzed at three different forming speeds. Experimental results proved that the blank temperature has a higher influence on LDR compared with other parameters especially at low forming speed.

scholarly journals Influence of process parameters on the deep drawing of stainless steel

2007 ◽  
Vol 43 (14) ◽  
pp. 1062-1067 ◽  
Author(s):  
R. Padmanabhan ◽  
M.C. Oliveira ◽  
J.L. Alves ◽  
L.F. Menezes
Keyword(s):  
Stainless Steel ◽  
Process Parameters ◽  
Deep Drawing ◽  
Influence Of Process Parameters
Sign in / Sign up

Export Citation Format

Share Document