Thermal conductivity of flake-shaped iron particles based magnetorheological suspension: Influence of nano-magnetic particle concentration

2020 ◽  
Vol 503 ◽  
pp. 166633 ◽  
Author(s):  
Ramesh V. Upadhyay ◽  
Mujiba S. Pisuwala ◽  
Kinnari Parekh ◽  
Kuldip Raj
Author(s):  
N. Y. Jagath B. Nikapitiya ◽  
Hyejin Moon

This paper reports an experimental study of thermal conductivity of room temperature ionic liquids (RTILs) based magnetic nanofluids. Various magnetic nanoparticles of metal oxides with high thermal conductivity, such as CuO, Al2O3, Fe3O4 and Carbon Nano Tubes (CNTs), were used to prepare magnetic nanofluids, while RTIL, trihexyl (tetradecyl) posphonium dicyanamide was used as the base fluid. Two major parameters that affect to the thermal conductivity enhancement of fluids were investigated. The effect of particle concentration and external magnetic fields were tested. It was observed that the magnetic nanofluids thermal conductivities increase with increment of particle concentration and external magnetic field parallel to the temperature gradient. Besides, it was observed that under higher magnetic fields, thermal conductivity enhancement tends to approach a saturation state. Surfactant was used to disperse magnetic nanoparticles within the RTILs. The transient hot wire method was used for this investigation.


2010 ◽  
Vol 5 ◽  
pp. 1324-1327
Author(s):  
A. García-Arribas ◽  
F. Martínez ◽  
E. Fernández ◽  
I. Ozaeta ◽  
G. Kurlyandskaya ◽  
...  

Author(s):  
J. Tielke ◽  
M. Maas ◽  
M. Castillo ◽  
K. Rezwan ◽  
M. Avila

Nanofluids are suspensions of nanoparticles in a base heat-transfer liquid. They have been widely investigated to boost heat transfer since they were proposed in the 1990s. We present a statistical correlation analysis of experimentally measured thermal conductivity of water-based nanofluids available in the literature. The influences of particle concentration, particle size, temperature and surfactants are investigated. For specific particle materials (alumina, titania, copper oxide, copper, silica and silicon carbide), separate analyses are performed. The conductivity increases with the concentration in qualitative agreement with Maxwell’s theory of homogeneous media. The conductivity also increases with the temperature (in addition to the improvement due to the increased conductivity of water). Surprisingly, only silica nanofluids exhibit a statistically significant effect of the particle size, whereby smaller particles lead to faster heat transfer. Overall, the large scatter in the experimental data prevents a compelling, unambiguous assessment of these effects. Taken together, the results of our analysis suggest that more comprehensive experimental characterizations of nanofluids are necessary to estimate their practical potential.


2019 ◽  
Vol 4 (1) ◽  
pp. 59-67 ◽  
Author(s):  
Ruyi Gan ◽  
Yaping Li ◽  
Song Qi ◽  
Mi Zhu ◽  
Miao Yu

Background: As an intelligent material, Magnetorheological Elastomer (MRE) has attracted extensive attention due to their excellent magnetic-induced properties. Aim: In addition to the matrix and interface, magnetic particle is the most critical factor in the magnetic properties of MRE. Particle size does not only affect on the magnetic properties of MRE, but also affects on interface and particle distribution. Therefore, studying the influence of particle size on viscoelastic properties is of great significance for the MRE. Methods: In this paper, several kinds of MREs containing Carbonyl Iron Particles (CIPs) with different sizes were prepared and characterized. The influences of frequency, strain and magnetic field on viscoelastic properties of these MRE samples have been discussed comprehensively. Results: The result shows that the particle size has a great impact on the performance of MRE, which indicates that the MRE performance can be improved by optimizing the particle size selection. In addition, possible physical mechanisms have been proposed to explain the effect of particles on MRE performance. Conclusion: This work can provide guidance for the performance improvement of MREs.


NANO ◽  
2016 ◽  
Vol 11 (08) ◽  
pp. 1650093 ◽  
Author(s):  
Deepak Khurana ◽  
Rajesh Choudhary ◽  
Sudhakar Subudhi

In the present study, the effect of particle concentration, particle diameter and temperature on the thermal conductivity and viscosity of Al2O3/water nanofluids was investigated experimentally using design of experiment approach (full factorial design). Variables were selected at two levels each: particle concentration (0.1–1%), particle diameter (20–40[Formula: see text]nm) and temperature (10–40[Formula: see text]C). It was observed that the thermal conductivity of the Al2O3/water nanofluids increases with increasing concentration and temperature and decreases with increase in particle diameter, while viscosity increases with increasing particle diameter. Results showed that the interaction effect of concentration and temperature also has significant effect on the thermal conductivity of Al2O3/water nanofluids. For viscosity, the interaction of particle diameter and temperature was important. Utility concept was used to optimize the properties collectively for better heat transfer performance. The optimal combination for high thermal conductivity and low viscosity was obtained at higher level of particle concentration (1%), lower level of particle diameter (20[Formula: see text]nm) and higher level of temperature (40[Formula: see text]C). At this condition the increment in thermal conductivity and viscosity compared to base fluid was 11.51% and 6.37%, respectively.


Sign in / Sign up

Export Citation Format

Share Document