Control oriented modeling and optimization of one dimensional packed bed model of underground coal gasification

2014 ◽  
Vol 24 (1) ◽  
pp. 269-277 ◽  
Author(s):  
Ali Arshad Uppal ◽  
Aamer Iqbal Bhatti ◽  
Erum Aamir ◽  
Raza Samar ◽  
Shahid Ahmed Khan
2015 ◽  
Vol 35 ◽  
pp. 11-20 ◽  
Author(s):  
Ali Arshad Uppal ◽  
Aamer Iqbal Bhatti ◽  
Erum Aamir ◽  
Raza Samar ◽  
Shahid Ahmed Khan

1985 ◽  
Vol 107 (4) ◽  
pp. 523-526 ◽  
Author(s):  
S. H. Advani ◽  
J. S. Torok ◽  
J. K. Lee

Exact solutions for the one-dimensional problem of a compressible fluid having a time-dependent pressure at the source (fracture face) and displacing a compressible reservoir fluid are generated. Special solutions for various cases represented by step, step with constant slope front, and sinusoidal pressure variations at the fracture face are derived. Numerical results and trends for fluid interface motion are revealed for selected cases. The applicability of the presented solutions to hydraulic fracturing is discussed. In addition, response solutions for problems in reservoir mechanics, underground coal gasification, and nuclear waste management can be similarly investigated.


Author(s):  
Anil N. Khadse ◽  
Mohammed Qayyumi ◽  
Sanjay M. Mahajani ◽  
Preeti Aghalayam

Underground Coal Gasification (UCG) is the process of in-situ conversion of coal into combustible products (syngas) which can be used either as fuel or as a chemical feedstock. In this study, the gasification channel is viewed as a one-dimensional packed bed reactor. The packed bed reactor model is solved incorporating chemical reactions and mass transfer effects. A pseudo-transient model is simulated for temperature and composition profiles of the gas and solid phases. The movements of the pyrolysis and the reaction front are obtained. The model results are in qualitative agreement with literature. The effects of various operating parameters are studied in detail. Steam/O2 ratio, inlet O2 and total pressure determine the solid temperature profile and hence the outlet gas composition. The simulations are performed for two sets of kinetics parameters. The solid temperature profile and outlet gas compositions change significantly with a change in kinetics parameters. The main motivation behind this study is to provide a theoretical base for understanding the critical aspects of UCG and to provide a tool which coupled with experiments will help in determining the commercial feasibility of the UCG process.


2020 ◽  
Author(s):  
Tata Sutardi ◽  
Linwei Wang ◽  
Nader Karimi ◽  
Manosh C Paul

Abstract In this study, a packed bed reactor is developed to investigate the gasification process of coal particles. The effects of coal particle size and heater temperature of reactor are examined to identify the thermochemical processes through the packed bed. Three different coal samples with varying size, named as A, B, and C, are used, and the experimental results show that the packed bed with smaller coal size has higher temperature, reaching 624oC, 582oC, and 569oC for coal A, B, and C respectively. In the case of CO formation, the smaller particle size has greater products in the unit of mole fraction over the area of generation. However, the variation in the porosity of the packed bed due to different coal particle sizes affects the reactions through the oxygen access. Consequently, the CO formation is least from the coal packed bed formed by the smallest particle size A. A second test with the temperature variations shows that the higher heater temperature promotes the chemical reactions, resulting in the increased gas products. The findings indicate the important role of coal seam porosity in UCG (underground coal gasification) application, as well as temperature to promote the syngas productions.


2020 ◽  
Vol 2 (1) ◽  
pp. 309-318
Author(s):  
A.N. KACHURIN ◽  
◽  
A.B. KOPILOV ◽  
G.V. FRIDLENDER ◽  
M.P. GANIN ◽  
...  

A mathematical model of the temperature regime of a coal bed during underground coal gasification in a filtration channel for new geotechnologies of Tula State University is developed. It is proposed to describe the unsteady temperature field of the coal seam with the one-dimensional heat conduction equation with the heat sink that depends on the temperature of the coal bed. The equation is solved for semi-infinite space. The results of computational experiments have shown that the temperature front from the fire face moves deep into the coal bed. Consequently, in the process of underground gasification, pre-heating of coal in the gasified block and thermal preparation take place. Quite quickly, after the formation of stable combustion of coal in the fire face, a stationary temperature profile is established.


2020 ◽  
Vol 7 (3) ◽  
pp. 476-492
Author(s):  
Tata Sutardi ◽  
Linwei Wang ◽  
Nader Karimi ◽  
Manosh C. Paul

Abstract In this study, a packed bed reactor was developed to investigate the gasification process of coal particles. The effects of coal particle size and heater temperature of reactor were examined to identify the thermochemical processes through the packed bed. Three different coal samples with varying size, named as A, B, and C, are used, and the experimental results show that the packed bed with smaller coal size has higher temperature, reaching 624 °C, 582 °C, and 569 °C for coal A, B, and C, respectively. In the case of CO formation, the smaller particle size has greater products in the unit of mole fraction over the area of generation. However, the variation in the porosity of the packed bed due to different coal particle sizes affects the reactions through the oxygen access. Consequently, the CO formation is least from the coal packed bed formed by the smallest particle size A. A second test with the temperature variations shows that the higher heater temperature promotes the chemical reactions, resulting in the increased gas products. The findings indicate the important role of coal seam porosity in underground coal gasification application, as well as temperature to promote the syngas productions.


2020 ◽  
Author(s):  
Tata Sutardi ◽  
Linwei Wang ◽  
Nader Karimi ◽  
Manosh C Paul

Abstract In this study, a packed bed reactor is developed to investigate the gasification process of coal particles. The effects of coal particle size and heater temperature of reactor are examined to identify the thermochemical processes through the packed bed. Three different coal samples with varying size, named as A, B, and C, are used, and the experimental results show that the coal packed bed with smaller size has higher temperature, reaching 624oC, 582oC, and 569oC for coal A, B, and C respectively. In the case of CO formation, the smaller particle size has greater products in the unit of mole fraction over the area of generation. However, the variation in the porosity of the coal packed bed due to different particle sizes affects the reactions through the oxygen access. Consequently, the CO formation is least from the coal packed bed formed by the smallest particle size A. A second test with the temperature variations shows that the higher heater temperature promotes the chemical reactions, resulting in the increased gas products. The findings indicate the important role of coal seam porosity in UCG (underground coal gasification) application, as well as temperature to promote the syngas productions.


2020 ◽  
Author(s):  
Tata Sutardi ◽  
Linwei Wang ◽  
Nader Karimi ◽  
Manosh C Paul

Abstract In this study, a packed bed reactor is developed to investigate the gasification process of coal particles. The effects of coal particle size and heater temperature of reactor are examined to identify the thermochemical processes through the packed bed. Three different coal samples with varying size, named as A, B, and C, are used, and the experimental results show that the coal packed bed with smaller size has higher temperature, reaching 624 o C, 582 o C, and 569 o C for coal A, B, and C respectively. In the case of CO formation, the smaller particle size has greater products in the unit of mole fraction over the area of generation. However, the variation in the porosity of the coal packed bed due to different particle sizes affects the reactions through the oxygen access. Consequently, the CO formation is least from the coal packed bed formed by the smallest particle size A. A second test with the temperature variations shows that the higher heater temperature promotes the chemical reactions, resulting in the increased gas products. The findings indicate the important role of coal seam porosity in UCG (underground coal gasification) application, as well as temperature to promote the syngas productions.


Sign in / Sign up

Export Citation Format

Share Document