Fabrication and performance of a stable micro/nano composite electret filter for effective PM2.5 capture

2020 ◽  
Vol 725 ◽  
pp. 138297 ◽  
Author(s):  
Rong-Rong Cai ◽  
Shu-Zheng Li ◽  
Li-Zhi Zhang ◽  
Yang Lei
Keyword(s):  
Nano Composite ◽  
And Performance ◽  
Electret Filter

Structural and performance properties of UV-assisted TiO2 deposited nano-composite PVDF/SPES membranes

Desalination ◽  
2012 ◽  
Vol 285 ◽  
pp. 31-38 ◽  
Author(s):  
Ahmad Rahimpour ◽  
Mohsen Jahanshahi ◽  
Arash Mollahosseini ◽  
Babak Rajaeian
Keyword(s):  
Nano Composite ◽  
Performance Properties ◽  
And Performance

Synthesis, characterization and performance evaluation of Fe3O4/PES nano composite membranes for microbial fuel cell

2018 ◽  
Vol 99 ◽  
pp. 222-229 ◽  
Author(s):  
Luca Di Palma ◽  
Irene Bavasso ◽  
Fabrizio Sarasini ◽  
Jacopo Tirillò ◽  
Debora Puglia ◽  
...  
Keyword(s):  
Performance Evaluation ◽  
Fuel Cell ◽  
Microbial Fuel Cell ◽  
Composite Membranes ◽  
Nano Composite ◽  
And Performance

Preparation and Performance of Co3O4/Polyaniline Nano-Composite for Supercapacitor

2011 ◽  
Vol 239-242 ◽  
pp. 2042-2045 ◽  
Author(s):  
Shu Ping Yu ◽  
Xiao Cong Chang ◽  
Zhong Ming Wang ◽  
Ke Fei Han ◽  
Hong Zhu
Keyword(s):  
Cyclic Voltammetry ◽  
Emulsion Polymerization ◽  
Cobalt Oxide ◽  
Electrochemical Behavior ◽  
Electrochemical Impedance ◽  
X Ray Diffraction ◽  
Nano Composite ◽  
X Ray ◽  
Scan Rate ◽  
And Performance

Cobalt oxide-Polyaniline (Co3O4/PANI) nanocomposites were prepared via inverted emulsion polymerization. The structure of the obtained composites were characterized by X-ray diffraction (XRD). The electrochemical behavior was studied by cyclic voltammetry(CV) and electrochemical impedance spectrometry(EIS) experiments. The Co3O4/PANI(1:2) composite calcined at 400°C exhibits the highest capacitance value of 357 F/g at the scan rate of 5mV/s.

Transmission Scanning Electron Microscopy and Energy Analysis with the Siemens ELMISKOP 101

1972 ◽  
Vol 30 ◽  
pp. 450-451
Author(s):  
H. M. Thieringer
Keyword(s):  
Objective Lens ◽  
Transmission Microscopy ◽  
Image Recording ◽  
Mode Of Operation ◽  
Scanning Transmission ◽  
Electron Microscopes ◽  
And Performance ◽  
Convergent Beam ◽  
Ray Path ◽  
Beam Diffraction

It has repeatedly been show that with conventional electron microscopes very fine electron probes can be produced, therefore allowing various micro-techniques such as micro recording, X-ray microanalysis and convergent beam diffraction. In this paper the function and performance of an SIEMENS ELMISKOP 101 used as a scanning transmission microscope (STEM) is described. This mode of operation has some advantages over the conventional transmission microscopy (CTEM) especially for the observation of thick specimen, in spite of somewhat longer image recording times.Fig.1 shows schematically the ray path and the additional electronics of an ELMISKOP 101 working as a STEM. With a point-cathode, and using condensor I and the objective lens as a demagnifying system, an electron probe with a half-width ob about 25 Å and a typical current of 5.10-11 amp at 100 kV can be obtained in the back focal plane of the objective lens.

Sign in / Sign up

Export Citation Format

Share Document