Catalytic versatility of erythrocyte carbonic anhydrase. VIII. Deuterium solvent isotope effects and apparent activation parameters for the enzyme-catalyzed hydrolysis of p-nitrophenyl acetate

Biochemistry ◽  
1968 ◽  
Vol 7 (11) ◽  
pp. 4139-4145 ◽  
Author(s):  
Yeshayau. Pocker ◽  
Joe Thomas. Stone
2021 ◽  
Vol 22 (14) ◽  
pp. 7394
Author(s):  
Kyoung Ho Park ◽  
Mi Hye Seong ◽  
Jin Burm Kyong ◽  
Dennis N. Kevill

A study was carried out on the solvolysis of 1-adamantyl chlorothioformate (1-AdSCOCl, 1) in hydroxylic solvents. The rate constants of the solvolysis of 1 were well correlated using the Grunwald–Winstein equation in all of the 20 solvents (R = 0.985). The solvolyses of 1 were analyzed as the following two competing reactions: the solvolysis ionization pathway through the intermediate (1-AdSCO)+ (carboxylium ion) stabilized by the loss of chloride ions due to nucleophilic solvation and the solvolysis–decomposition pathway through the intermediate 1-Ad+Cl− ion pairs (carbocation) with the loss of carbonyl sulfide. In addition, the rate constants (kexp) for the solvolysis of 1 were separated into k1-Ad+Cl− and k1-AdSCO+Cl− through a product study and applied to the Grunwald–Winstein equation to obtain the sensitivity (m-value) to change in solvent ionizing power. For binary hydroxylic solvents, the selectivities (S) for the formation of solvolysis products were very similar to those of the 1-adamantyl derivatives discussed previously. The kinetic solvent isotope effects (KSIEs), salt effects and activation parameters for the solvolyses of 1 were also determined. These observations are compared with those previously reported for the solvolyses of 1-adamantyl chloroformate (1-AdOCOCl, 2). The reasons for change in reaction channels are discussed in terms of the gas-phase stabilities of acylium ions calculated using Gaussian 03.


1968 ◽  
Vol 21 (7) ◽  
pp. 1733 ◽  
Author(s):  
SF Lincoln ◽  
DR Stranks

The rates of hydrolysis of phosphato complexes of cobalt(111) in sodium hydroxide concentrations ranging from 0.02M to 0.37M, and at several ionic strengths, have been measured with a tracer technique. Bidentate phosphato complexes exhibit the same rates of hydrolysis as the corresponding monodentate complexes, due to a rapid conversion of the bidentate into the monodentate form. The general rate law for base hydrolysis of all the phosphato complexes is: d[PO34]/dt = {kH2O + kOH[OH-]}[complex] At 60� and at unit ionic strength, the rate constants for the complexes cis-[Co(NH3)4OH.PO4]-, cis-[Co en2OH.PO4]-, and [Co(NH3)5PO4] respectively are: 103kH2O (min-l) 85.0, 2.0, <1; and 103kOH (1. mole-1 min-l) 42.7, 12.0, 69.5. Mechanistic conclusions have been based on the measured enthalpies and entropies of activation and deuterium solvent isotope effects. For all complexes, kH2O is identified with an aquation mechanism involving synchronous interchange of the phosphate and solvent water between the first and second coordination spheres of the complexes. In the case of the tetrammine and bis(ethylenediamine) complexes, kOH is identified with a process involving synchronous interchange of phosphate and hydroxide ion between the first and second coordination spheres of the complexes. In the case of the pentammine complex, an SN2CB mechanism is considered to be more probable. A comparison with the base hydrolysis of halogen complexes of cobalt(111) is presented.


1973 ◽  
Vol 51 (4) ◽  
pp. 597-603 ◽  
Author(s):  
E. C. F. Ko ◽  
R. E. Robertson

The pseudo-thermodynamic parameters, ΔH≠, ΔS≠, and ΔCp≠ and the kinetic solvent isotope effects have been determined for the three alkyl-phosphorochloridates, where the alkyl group is ethylisopropyl and n-propyl; for tetra-methyl and tetra-ethyl phosphorodiamidic chlorides; the di-n-propyl and di-isopropyl analog, the di(isopropylmethylcarbinyl)phosphorochloridate and the tetra-ethylthiophosphorodiamidic chloride. These compounds have a potential relationship to compounds used as insecticides and as polymers. The mechanism of reaction is discussed on the basis of these data.


1999 ◽  
Vol 77 (5-6) ◽  
pp. 997-1004 ◽  
Author(s):  
X L Armesto ◽  
M Canle L. ◽  
V García ◽  
J A Santaballa

A kinetic study of the mechanism of oxidation of Ala-Gly and Pro-Gly by aqueous chlorine has been carried out. Among other experimental facts, the deuterium solvent isotope effects were used to clarify the mechanisms involved. In a first stage, N-chlorination takes place, and then the (N-Cl)-dipeptide decomposes through two possible mechanisms, depending on the acidity of the medium. The initial chlorination step shows a small isotope effect. In alkaline medium, two consecutive processes take place: first, the general base-catalyzed formation of an azomethine (β ca. 0.27), which has an inverse deuterium solvent isotope effect (kOH-/kOD- ~ 0.8). In a second step, the hydrolysis of the azomethine intermediate takes place, which is also general base-catalyzed, without deuterium solvent isotope effect, the corresponding uncatalyzed process having a normal deuterium solvent isotope effect (kH2O/kD2O ~ 2). In acid medium, the (N-Cl)-dipeptide undergoes disproportionation to a (N,N)-di-Cl-dipeptide, the very fast decomposition of the latter in deuterium oxide preventing a reliable estimation of the solvent isotope effect.Key words: chlorination, deuterium isotope effects, fractionation factors, peptide oxidation, water treatment.


2007 ◽  
Vol 2007 (6) ◽  
pp. 365-369 ◽  
Author(s):  
Dennis N. Kevill ◽  
Zoon Ha Ryu

The specific rates of solvolysis of benzenesulfonic anhydride (1) and p-toluenesulfonic anhydride (2) have been measured conductometrically at −10°C in 34 solvents for 1 and 33 solvents for 2. Studies at higher temperatures have allowed extrapolated values in additional solvents to be calculated. All of the values, for 35 solvents for 1 and for 37 solvents for 2, have been used in an extended Grunwald–Winstein equation treatment using NT and YOTs values. Activation parameters in several solvents and kinetic solvent isotope effects (MeOH/MeOD) have been determined for both substrates. Product selectivity values ( S) have been determined for binary mixtures of water with ethanol, methanol, or 2, 2, 2-trifluoroethanol. The results from the kinetic and product studies are compared to those previously reported for methanesulfonic anhydride (3). An SN2 mechanism is proposed for the solvolytic displacement reactions of the three substrates in all of the solvents used in the investigation.


Sign in / Sign up

Export Citation Format

Share Document