Episodic Slow Slip Events and Overlying Plate Seismicity at the Southernmost Ryukyu Trench

Abstract We applied tomographic inversion and receiver function analysis to seismic data from ocean-bottom seismometers and land-based stations to understand the structure and its relationship with slow slip events off Boso, Japan. First, we delineated the upper boundary of the Philippine Sea Plate based on both the velocity structure and the locations of the low-angle thrust-faulting earthquakes. The upper boundary of the Philippine Sea Plate is distorted upward by a few kilometers between 140.5 and 141.0°E. We also determined the eastern edge of the Philippine Sea Plate based on the delineated upper boundary and the results of the receiver function analysis. The eastern edge has a northwest–southeast trend between the triple junction and 141.6°E, which changes to a north–south trend north of 34.7°N. The change in the subduction direction at 1–3 Ma might have resulted in the inflection of the eastern edge of the subducted Philippine Sea Plate. Second, we compared the subduction zone structure and hypocenter locations and the area of the Boso slow slip events. Most of the low-angle thrust-faulting earthquakes identified in this study occurred outside the areas of recurrent Boso slow slip events, which indicates that the slow slip area and regular low-angle thrust earthquakes are spatially separated in the offshore area. In addition, the slow slip areas are located only at the contact zone between the crustal parts of the North American Plate and the subducting Philippine Sea Plate. The localization of the slow slip events in the crust–crust contact zone off Boso is examined for the first time in this study. Finally, we detected a relatively low-velocity region in the mantle of the Philippine Sea Plate. The low-velocity mantle can be interpreted as serpentinized peridotite, which is also found in the Philippine Sea Plate prior to subduction. The serpentinized peridotite zone remains after the subduction of the Philippine Sea Plate and is likely distributed over a wide area along the subducted slab.

Download Full-text

Estimation of frictional properties and slip evolution on a long-term slow slip event fault with the ensemble Kalman filter: numerical experiments

Geophysical Journal International ◽

10.1093/gji/ggz415 ◽

2019 ◽

Vol 219 (3) ◽

pp. 2074-2096 ◽

Cited By ~ 2

Author(s):

Kazuro Hirahara ◽

Kento Nishikiori

Keyword(s):

Surface Displacement ◽

Slip Rate ◽

Slow Slip ◽

Slow Slip Events ◽

Actual Distribution ◽

Frictional Properties ◽

Data Analyses ◽

Bungo Channel ◽

Megathrust Faults ◽

Gnss Data

Summary A variety of slow slip events at subduction zones have been observed. They can be stress meters for monitoring the stress state of megathrust faults during their earthquake cycles. In this study, we focus on long-term slow slip events (LSSEs) recurring at downdip portions of megathrust faults among such slow earthquakes. Data analyses and simulation studies of LSSEs have so far been executed independently. In atmosphere and ocean sciences, data assimilations that optimally combine data analyses and simulation studies have been developed. We develop a method for estimating frictional properties and monitoring slip evolution on an LSSE fault, with a sequential data assimilation method, the ensemble Kalman filter (EnKF). We executed numerical twin experiments for the Bungo Channel LSSE fault in southwest Japan to validate the method. First, based on a rate- and state-dependent friction law, we set a rate-weakening circular LSSE patch on the rate-strengthening flat plate interface, whose critical nucleation size is larger than that of the patch, and reproduced the observed Bungo Channel LSSEs with recurrence times of approximately 7 yr and slip durations of 1 yr. Then, we synthesized the observed data of surface displacement rates at uniformly distributed stations with noises from the simulated slip model. Using our EnKF method, we successfully estimated the frictional parameters and the slip rate evolution after a few cycles. Secondly, we considered the effect of the megathrust fault existing in the updip portion of the LSSE fault, as revealed by kinematic inversion studies of Global Navigation Satellite System (GNSS) data and added this locked region with a slip deficit rate in the model. We estimated the slip rate on the locked region only kinematically, but the quasi-dynamic equation of motion in each LSSE fault cell includes the stress term arising from the locked region. Based on this model, we synthesized the observed surface displacement rate data for the actual distribution of GNSS stations and executed EnKF estimations including the slip rate on the locked region. The slip rate on the locked region could be quickly retrieved. Even for the actual distribution of GNSS stations, we could successfully estimate frictional parameters and slip evolution on the LSSE fault. Thus, our twin numerical experiments showed the validity of our EnKF method, although we need further studies for actual GNSS data analyses.

Download Full-text