Thermal conversion of an anion-exchange resin: a new catalytic-graphitization route to prepare porous carbons with a high graphitization degree for supercapacitors

RSC Advances ◽  
2016 ◽  
Vol 6 (113) ◽  
pp. 112576-112580 ◽  
Author(s):  
Haifeng Xu

High-graphitization porous carbons were synthesized via an anion-exchange-assisted catalytic graphitization method for supercapacitors with high energy density.

1966 ◽  
Author(s):  
S. CHODOSH ◽  
E. KATSOULIS ◽  
M. ROSANSKY

2019 ◽  
Author(s):  
Zhao-Yang Zhang ◽  
Tao LI

Solar energy and ambient heat are two inexhaustible energy sources for addressing the global challenge of energy and sustainability. Solar thermal battery based on molecular switches that can store solar energy and release it as heat has recently attracted great interest, but its development is severely limited by both low energy density and short storage stability. On the other hand, the efficient recovery and upgrading of low-grade heat, especially that of the ambient heat, has been a great challenge. Here we report that solar energy and ambient heat can be simultaneously harvested and stored, which is enabled by room-temperature photochemical crystal-to-liquid transitions of small-molecule photoswitches. The two forms of energy are released together to produce high-temperature heat during the reverse photochemical phase change. This strategy, combined with molecular design, provides high energy density of 320-370 J/g and long-term storage stability (half-life of about 3 months). On this basis, we fabricate high-performance, flexible film devices of solar thermal battery, which can be readily recharged at room temperature with good cycling ability, show fast rate of heat release, and produce high-temperature heat that is >20<sup> o</sup>C higher than the ambient temperature. Our work opens up a new avenue to harvest ambient heat, and demonstrate a feasible strategy to develop high-performance solar thermal battery.


2019 ◽  
Author(s):  
Zhao-Yang Zhang ◽  
Tao LI

Solar energy and ambient heat are two inexhaustible energy sources for addressing the global challenge of energy and sustainability. Solar thermal battery based on molecular switches that can store solar energy and release it as heat has recently attracted great interest, but its development is severely limited by both low energy density and short storage stability. On the other hand, the efficient recovery and upgrading of low-grade heat, especially that of the ambient heat, has been a great challenge. Here we report that solar energy and ambient heat can be simultaneously harvested and stored, which is enabled by room-temperature photochemical crystal-to-liquid transitions of small-molecule photoswitches. The two forms of energy are released together to produce high-temperature heat during the reverse photochemical phase change. This strategy, combined with molecular design, provides high energy density of 320-370 J/g and long-term storage stability (half-life of about 3 months). On this basis, we fabricate high-performance, flexible film devices of solar thermal battery, which can be readily recharged at room temperature with good cycling ability, show fast rate of heat release, and produce high-temperature heat that is >20<sup> o</sup>C higher than the ambient temperature. Our work opens up a new avenue to harvest ambient heat, and demonstrate a feasible strategy to develop high-performance solar thermal battery.


2015 ◽  
Vol 5 (1) ◽  
pp. 11
Author(s):  
Anies Mutiari ◽  
Wiratni Wiratni ◽  
Aswati Mindaryani

Pemurnian biogas telah banyak dilakukan untuk menghilangkan kadar CO2  dan meningkatkan kandungan CH4  yang terkandung di dalamnya. Kandungan CH4 yang tinggi akan memberikan unjuk kerja yang lebih baik. Model  matematis proses adsorpsi CO2 disusun berdasarkan teori lapisan film antar fasa, dimana pada proses yang ditinjau terdapat tiga fase yaitu gas, cair dan padat. Model matematis dari data eksperimental   kecepatan dan kesetimbangan proses adsorpsi CO2 melalui mekanisme pertukaran ion di suatu kolom adsorpsi telah dibuat. Model ini dibuat untuk mencari konstanta yang dapat dipergunakan pada proses scale up data laboratorium ke skala pilot plant. Parameter proses kecepatan yang dicari nilainya adalah koefisien transfer massa massa volumetris CO2 pada fase cair (kLa), koefisien transfer massa volumetris CO2 pada fasegas (kGa) dan tetapan laju reaksi (k1 dan k2). Pada hasil penelitian ini ditunjukkan bahwa nilai parameter yang diperoleh sesuai hasil fitting data dengan model matematis yang digunakan, yaitu model transfer massa pada lapisan film antar fase secara seri: adalah kGa, kla, k1 dan k2  dengan nilai Sum of Squares Error (SSE) rata-rata 0,0431. Perbandingan nilai kGa hasil simulasi dan teoritisnya memberikan kesalahan rata-rata 18,79%. Perbandingan nilai kLa hasil simulasi dan teoritis memberikan kesalahan rata-rata 7,92%.Kata kunci: model matematis, adsorpsi CO2, pemurnian biogas


2013 ◽  
Vol 28 (11) ◽  
pp. 1207-1212 ◽  
Author(s):  
Jian-Wen LI ◽  
Ai-Jun ZHOU ◽  
Xing-Quan LIU ◽  
Jing-Ze LI

2018 ◽  
Vol 28 (5) ◽  
pp. 273-278
Author(s):  
Beomhee Kang ◽  
Soonhyun Hong ◽  
Hongkwan Yoon ◽  
Dojin Kim ◽  
Chunjoong Kim

Sign in / Sign up

Export Citation Format

Share Document