Two methods of measuring the electrical conductivity of the dried collodion membrane in contact with an electrolyte solution are described and the results of such measurements with different electrolytes in different ranges of concentration recorded. Some of the difficulties encountered in making these measurements are outlined. Of special interest was the fact that each membrane with each electrolyte showed a maximum level of resistance at a certain point in the dilution scale, a level which was not surpassed by further dilution. It is believed that this level was fixed by the collodion itself rather than by the contiguous electrolyte solution. Its existence limited the results available for reasonable interpretation. In relatively concentrated solutions the conductivity was shown to be approximately proportional to the concentration. With different electrolytes in the same concentration it was shown that the conductivities varied much more than in simple solutions without a membrane and that they fell in the order HCl > KCl > NaCl > LiCl.
A method was described whereby the electrolyte content of a membrane in contact with different chloride solutions could be determined. It was shown that a membrane saturated with either 0.5 N HCl or 0.5 N KCl had practically the same total electrolyte content whereas the same membrane in contact with 0.5 N LiCl contained only half the quantity. These results were used in interpreting the conductivity data, the evidence presented strongly suggesting that two factors are operative in causing the widely divergent conductivities recorded with different electrolytes. The first factor depended on the quantity of electrolyte which can enter the membrane pores, a quantity dependent on the size of the pores and the volume of the larger of the two hydrated ions of the electrolyte. This factor was the chief one in determining the difference in conductivity between KCl and LiCl. The second factor was concerned with differences in the mobility of the various cations within the membrane brought about by friction between the moving ions and the pore walls. With KCl and HCl the quantity of electrolytes entering the membrane was in each case the same, being determined by the size of the larger Cl- ion. The widely different conductivity values were explained as due to the changes in the mobility of the two cations within the membrane pores.
STUDIES ON PERMEABILITY OF MEMBRANES
