With the development of intelligent high voltage switch, online gas insulated switchgear discharge detection technology has been more and more widely applied. Because of the high sensing sensitivity and good antiinterference performance of build-in partial discharge sensor, it is currently
required to install them on gas insulated switchgear products with voltage levels of 220 kV and above at the factory. The structural parameters of the build-in partial discharge sensor is of great importance to its sensing sensitivity. Therefore, in this paper, the influence of the structure
change on the sensitivity of axisymmetric gas insulated switchgear build-in partial discharge sensor is experimentally studied. A practical gas insulated switchgear test model was established in the laboratory, and the frequency domain measurement system based on Spectrogram analyzer and synchronous
sweep signal generator was adopted. By comparing the insertion loss generated by the build-in sensor when receiving sweep signal, the influence of structural parameter changes on the sensing sensitivity was analyzed. The results show that the diameter of the build-in sensor should be matched
with the diameter of the hand-hole. The match of the larger diameter of the hand-hole and the smaller diameter of the sensor can increase the sensing sensitivity, but when the diameter of the sensor is close to the diameter of the hand-hole, the sensitivity will be significantly reduced. In
addition, metal bolts with the sensor electrode and its insulating support fixed to the hand-hole cover can also result in a significant reduction in sensing sensitivity. Using the same measuring principle and system, the propagation attenuation characteristics of partial discharge ultra high
frequency signal in gas insulated switchgear typical structures (linear and L-shaped structures) are also experimentally studied. The results show that the average attenuation of partial discharge ultra high frequency signal in gas insulated switchgear along the linear distance is 0.3 dB/m,
and the attenuation through every L-shaped structure is 4.2 dB.
A Study on the Extraction Method of Partial Discharge Features in Gas Insulated Switchgear Based on Ultra-High Frequency Signal Envelope
