Deconvolution Method for Eliminating Reference Signal Coupling/Reflections in Bistatic SAR

The low-frequency noise generated by the vibration of the compressor in the machinery room of refrigerators is considered as annoying sound. Active noise control is used to reduce this noise without any change in the design of the compressor in the machinery room. In configuring the control system, various signals are measured and analyzed to select the reference signal that best represents the compressor noise. As the space inside the machinery room is small, the size of a speaker is limited, and the magnitude of the controller transfer function is designed to be small at low frequencies, the controller uses FIR filter structure converged by the FxLMS algorithm using the pre-measured time signal. To manage the convergence speed for each frequency, the frequency-weighting function is applied to FxLMS algorithm. A series of measurements are performed to design the controller and to evaluate the control performance. After the control, the sound power transmitted by the refrigerator is reduced by 9 dB at the first dominant frequency (408 Hz in this case) and 3 dB at the second dominant frequency (459 Hz here), and the overall sound power decreases by 2.6 dB. Through this study, an active control system for the noise generated by refrigerator compressors is established.

Download Full-text

Implementation of a single-channel active noise control system with multiple reference sensors

Noise Control Engineering Journal ◽

10.3397/1/376830 ◽

2020 ◽

Vol 68 (5) ◽

pp. 358-366

Author(s):

H.E. Oh ◽

W.B. Jeong ◽

C. Hong

Keyword(s):

Single Channel ◽

Control Method ◽

Reference Signal ◽

Active Noise Control ◽

Multiple Source ◽

Weighted Sum ◽

Reference Signals ◽

Feedforward Controller ◽

Channel Control ◽

Source Signals

When multiple sources contribute competitively to the noise level, multi-channel control architecture is needed, leading to more cost and time for control computation. We, hence, are concerned with a single-channel control method with a single-reference signal obtained from a linear combination of the multiple source signals. First, we selected 3 source signal sensors for the reference signals and the error sensor, selected a proper actuator and designed the controllers: 3 cases of single-channel feedforward controllers with a single-reference signal respectively from the source signals, a multi-channel feedforward controller with the reference signals from the source signals, and the proposed controller with the reference signal from weighted sum of the source signals. The weighting factors and the filter coefficients of the controller were determined by the FxLMS algorithm. An experiment was then performed to confirm the effectiveness of the proposed method comparing the control performance with other methods for a tower air conditioner. The overall sound pressure level (SPL) detected by the error sensor is compared to evaluate their performance. The reduction in the overall SPL was obtained by 4.74 dB, 1.96 dB and 6.62 dB, respectively, when using each of the 3 reference signals. Also, the overall SPL was reduced by 7.12 dB when using the multi-reference controller and by 7.66 dB when using the proposed controller. Conclusively, under the multiple source contribution, a single-channel feed forward controller with the reference signal from a weighted sum of the source signals works well with lower cost than multi-channel feedforward controller.

Download Full-text