Ion-Beam Mixing and Amorphization in Au/Zr Bilayers

1988 ◽  
Vol 100 ◽  
Author(s):  
Fu-Rong Ding ◽  
P. R. Okamoto ◽  
L. E. Rehn
Keyword(s):  
Electron Microscope ◽  
Ion Beam ◽  
Low Energy ◽  
Inert Gas ◽  
Arrhenius Behavior ◽  
Ion Beam Mixing ◽  
Bilayer Films ◽  
Voltage Electron ◽  
High Voltage Electron Microscope

ABSTRACTAu/Zr bilayer films with inert-gas markers were produced by low energy (< 4 keV) implantation. Mass transport was measured during ion-beam mixing with 1 MeV Kr at several temperatures between 330 and 540K. Two distinct regimes of apparent Arrhenius behavior were found with activation enthalpies of 0.06 and 0.9 eV in the temperature range 330–440K and 460–540K, respectively. Microstructural changes during ion-beam mixing were studied in situ, in a high voltage electron microscope. Heterogeneous nucleation of an amorphous phase was observed during mixing. The results are compared with similar studies reported previously in Ni/Zr bilayer specimens.

Solid-state amorphization, interdiffusion, and ion-beam mixing in Au/Zr and Ni/Zr

1989 ◽  
Vol 4 (6) ◽  
pp. 1444-1449 ◽  
Author(s):  
Fu-Rong Ding ◽  
P. R. Okamoto ◽  
L. E. Rehn
Keyword(s):  
Solid State ◽  
Ion Beam ◽  
X Ray Diffraction ◽  
Temperature Dependent ◽  
Ion Beam Mixing ◽  
Enhanced Diffusion ◽  
Bilayer Films ◽  
Voltage Electron ◽  
Radiation Enhanced Diffusion

Inert-gas markers, Rutherford backscattering, and x-ray diffraction were used to investigate solid-state interdiffusion in Ni/Zr and Au/Zr bilayer films as a function of temperature; microstructural studies during annealing were performed in situ, in a high-voltage electron microscope. Au, in contrast to Ni, is not an anomalously fast diffuser in crystalline Zr. Nevertheless, an amorphous product phase was found in both alloy systems for reaction temperatures  550 K; heterogeneous nucleation of the amorphous phase was observed in Au/Zr. The interdiffusion data reveal two distinct Arrhenius regimes, 330–∼470 K and ∼480–550 K, with quite different apparent activation enthalpies. These thermal interdiffusion results are compared with temperature dependent studies of ion-beam mixing in similar bilayer specimens. This comparison indicates that the enhanced efficiencies observed for ion-beam mixing above ∼480 K result from the as-prepared metastable microstructurc, and are not due to radiation-enhanced diffusion.

In-situ electrical-resistivity measurements in the high-voltage electron microscope

1978 ◽  
Vol 36 (1) ◽  
pp. 68-69
Author(s):  
W. E. King
Keyword(s):  
Electrical Resistivity ◽  
Electron Microscope ◽  
High Voltage ◽  
Resistivity Measurements ◽  
Voltage Electron ◽  
High Voltage Electron Microscope ◽  
High Voltage Electron ◽  
Wide Range ◽  
Helium Gas

A side-entry type, helium-temperature specimen stage that has the capability of in-situ electrical-resistivity measurements has been designed and developed for use in the AEI-EM7 1200-kV electron microscope at Argonne National Laboratory. The electrical-resistivity measurements complement the high-voltage electron microscope (HVEM) to yield a unique opportunity to investigate defect production in metals by electron irradiation over a wide range of defect concentrations.A flow cryostat that uses helium gas as a coolant is employed to attain and maintain any specified temperature between 10 and 300 K. The helium gas coolant eliminates the vibrations that arise from boiling liquid helium and the temperature instabilities due to alternating heat-transfer mechanisms in the two-phase temperature regime (4.215 K). Figure 1 shows a schematic view of the liquid/gaseous helium transfer system. A liquid-gas mixture can be used for fast cooldown. The cold tip of the transfer tube is inserted coincident with the tilt axis of the specimen stage, and the end of the coolant flow tube is positioned without contact within the heat exchanger of the copper specimen block (Fig. 2).

Dislocation Dynamics in Icosahedral Al-Pd-Mn Single Quasicrystals

2000 ◽  
Vol 643 ◽  
Author(s):  
Ulrich Messerschmidt ◽  
Martin Bartsch ◽  
Bert Geyer ◽  
Lars Ledig ◽  
Michael Feuerbacher ◽  
...  
Keyword(s):  
Electron Microscope ◽  
Stress Exponent ◽  
High Voltage ◽  
Dislocation Dynamics ◽  
Slip Mechanism ◽  
Voltage Electron ◽  
High Voltage Electron Microscope ◽  
Slip Planes ◽  
Slip Traces

AbstractThe paper reviews results from in situ straining experiments on Al-Pd-Mn single quasicrystals in a high-voltage electron microscope. Slip planes were determined from the orientation and width of slip traces. Dislocations are generated by a specific cross slip mechanism. On some slip traces, dislocations move at two distinctly different velocities. A stress exponent was determined on a single dislocation by observing its displacement under decreasing load. The in situexperiments reveal the behaviour of individual dislocations in a temperature range where the deformation of bulk specimens is strongly affected by recovery.

scholarly journals In Situ Ion Beam Research In Argonne's Intermediate Voltage Electron Microscope

1996 ◽  
Vol 439 ◽  
Author(s):  
Charles W. Allen ◽  
Edward A. Ryan
Keyword(s):  
Electron Microscope ◽  
Ion Irradiation ◽  
Noble Gas ◽  
Ion Beam ◽  
Voltage Electron ◽  
In Situ Experiments ◽  
User Facility ◽  
New Instrumentation ◽  
Electron Microscopes

AbstractSince Fall 1995, a state-of-the-art intermediate voltage electron microscope (IVEM) has been operational in the HVEM-Tandem Facility with in situ ion irradiation capabilities similar to those of the HVEM of the Facility. A 300 kV Hitachi H-9000NAR is interfaced to the two ion accelerators of the Facility, with a demonstrated point-topoint spatial resolution for imaging of 0.25 nm with the ion beamline attached to the microscope. The IVEM incorporates a Faraday cup system for ion dosimetry with measurement aperture 6.5 cm from the TEM specimen, which was described in Symposium A of the 1995 MRS Fall Meeting. The IVEM is now employed for a variety of in situ ion beam studies ranging from low dose ion damage experiments with GaAs, in which damage zones individual displacement cascades are observed, to implantation studies in metals, in which irradiation-induced noble gas precipitate mobility is studied in real time. In this presentation, the new instrumentation and its specifications will be described briefly, several basic concepts relating to in situ experiments in transmission electron microscopes will be summarized and examples of in situ experiments will be presented which exploit the experimental capabilities of this new user facility instrumentation.

Sign in / Sign up

Export Citation Format

Share Document