scholarly journals High Strain Rate Superplasticity of Powder Metallurgy Si3N4 Reinforced Al-Zn-Mg Alloy Composites.

1995 ◽  
Vol 42 (6) ◽  
pp. 758-761 ◽  
Author(s):  
Mamoru Mabuchi ◽  
Kenji Higashi
Keyword(s):  
Powder Metallurgy ◽  
High Strain Rate ◽  
Strain Rate ◽  
High Strain ◽  
Mg Alloy

High Strain Rate Blow Formability of Newly Developed Al-Mg-High-Mn Alloy

2012 ◽  
Vol 735 ◽  
pp. 271-277 ◽  
Author(s):  
Tomoyuki Kudo ◽  
Akira Goto ◽  
Kazuya Saito
Keyword(s):  
Grain Size ◽  
High Strain Rate ◽  
Strain Rate ◽  
Mass Production ◽  
High Strain ◽  
Mg Alloy ◽  
Strain Rates ◽  
Fine Grain ◽  
Aa5083 Alloy ◽  
Complex Parts

Blow forming accompanied with superplasticity makes possible the forming of complex parts, which cannot be formed by cold press forming. The conventional superplastic AA5083 alloy ‘ALNOVI-1’ developed by the Furukawa-Sky Aluminum Corp. shows high superplasticity because of its fine grain and is widely used for blow forming. However, for mass production of components, an Al-Mg alloy with finer-sized grains is needed. In this research, the newly developed high Mn version of the Al-Mg alloy ‘ALNOVI-U’ is used, and this material possesses grains finer than those of the conventional AA5083 alloy. The effects of finer grain size on the blow formability at high strain rates over 10-2/s and the properties of the resulting moldings were studied.

High-strain-rate Superplasticity in a Nanostructured Al-Mg Alloy

2005 ◽  
Vol 7 (4) ◽  
pp. 247-250 ◽  
Author(s):  
B. Q. Han ◽  
E.J. Lavernia
Keyword(s):  
High Strain Rate ◽  
Strain Rate ◽  
High Strain ◽  
Mg Alloy
Sign in / Sign up

Export Citation Format

Share Document