scholarly journals DYNAMIC EQUILIBRIUM FOR DETERMINING DRAIN SPACING FOR DIFFERENT SOILS

2005 ◽  
Vol 13 (2) ◽  
pp. 1-11
Author(s):  
Dr.Abdul-Sattar Aldabagh ◽  
Entesar M.Ghazal
Author(s):  
Eva-Maria Mandelkow ◽  
Eckhard Mandelkow ◽  
Joan Bordas

When a solution of microtubule protein is changed from non-polymerising to polymerising conditions (e.g. by temperature jump or mixing with GTP) there is a series of structural transitions preceding microtubule growth. These have been detected by time-resolved X-ray scattering using synchrotron radiation, and they may be classified into pre-nucleation and nucleation events. X-ray patterns are good indicators for the average behavior of the particles in solution, but they are difficult to interpret unless additional information on their structure is available. We therefore studied the assembly process by electron microscopy under conditions approaching those of the X-ray experiment. There are two difficulties in the EM approach: One is that the particles important for assembly are usually small and not very regular and therefore tend to be overlooked. Secondly EM specimens require low concentrations which favor disassembly of the particles one wants to observe since there is a dynamic equilibrium between polymers and subunits.


1985 ◽  
Vol 54 (04) ◽  
pp. 857-861 ◽  
Author(s):  
Andrea Remuzzi ◽  
Lucia Raffaella Languino ◽  
Vincenzo Costantini ◽  
Vincenzo Guardabasso ◽  
Giovanni de Gartano ◽  
...  

SummaryThe adherence of human 3H-adenine-labeled platelets to rat subendothelium was quantitated using a rotating probe device. Platelet adhesion increased in relation to the rotation time, reaching a plateau value in about 4-6 min without any further increase. A non-linear fitting analysis of experimental data allowed calculations of initial rate and plateau value of platelet adhesion. Increasing the shear rates (from 35 to 150 sec-1) or the hematocrit (from 10% to 40%), both the adhesion rate and the plateau value were increased. When different platelet concentrations were used the adhesion rate and the plateau calculated increased with platelet concentration. Different plateau values were obtained in the experimental conditions considered. This suggests that the plateau was not reached for the complete occupation of the subendothelial surface by the adherent platelets. Experiments using two different vessels rotated in the same platelet suspension or, viceversa, the same vessel rotated successively in two fresh platelet suspensions, showed that the plateau was not determined by reduced platelet reactivity. Rotating the same vessel first in radiolabeled platelets, until the plateau was reached, and secondly in non labeled platelets, or viceversa, showed that the plateau was indeed a dynamic condition where the number of platelets adhering and detaching reached equilibrium. These observations suggest that the platelet adhesion to subendothelium is the final equilibrium of two platelet fluxes, one adhering to the surface and another detaching from the surface.


2007 ◽  
Vol 35 (2) ◽  
pp. 597-600
Author(s):  
Ida Kincses ◽  
Tibor Filep ◽  
Péter Nagy ◽  
Andrea Kovács

2014 ◽  
Vol 10 (1) ◽  
pp. 35-51
Author(s):  
I. Czupy

Concerns about climate change and fossil fuel shortages are encouraging interest in stumps, as alternative energy sources. Stumps are an almost unused resource in the context of bio fuels. Stump harvesting signifies an intensification of forest management compared with conventional stem-only or above-ground biomass-only harvesting. There are many benefits of stump harvesting. These include: the production of wood fuel, fossil fuel substitution, and improved soil preparation.Removing tree trunks in Hungary has been going on according to the principle of stump extraction, which means stumps are removed by grabbing technology. Experiments have been carried out to reduce the extraction force. In the Great Hungarian Lowland, where large areas require the operation implementation, stump extraction is done by special, hydraulic driven baggers equipped with a special bucket. During operation of the equipment, we carried out measurements of the extraction force and the time requirement. The experiments are designed to carry out the measurements with different soils and different tree species. According to our proposal the suitable force and torque required to remove stumps can be significantly reduced if before the lifting the soil — root connection is loosened. One of the possible ways to implement this task is the use of vibration. Since relatively great vibration power and wide domain of frequency are necessary, therefore we prepared the loosening machinery elements of alternating-current hydraulics system. Based on constructions variants we created a tractor-mounted experimental alternating-current hydraulic stump-loosening machine. It was designed with the ability to produce horizontal vibration in order to loosen stumps.


Sign in / Sign up

Export Citation Format

Share Document