Research on Short-Circuit Current of Marine AC Power System Based on Combined Programming

2012 ◽  
Vol 433-440 ◽  
pp. 2270-2275
Author(s):  
Chun Lai Zhang ◽  
Hao Liang Wang ◽  
Dian Li Zhao
Keyword(s):  
Power System ◽  
Short Circuit ◽  
Short Circuit Current ◽  
Time Curve ◽  
Current Time ◽  
Ac Power

Based on the combined programming for VB, Excel and MATLAB, the paper makes research on short-circuit current of marine AC power system. This method can not only draw precise calculations, but also has the function of making short-circuit current time curve. And it opens up a new way to study the short-circuit current.

Protection Coordination of 33/11 kV Power Distribution Substation in Iraq

2021 ◽  
Vol 39 (5A) ◽  
pp. 723-737
Author(s):  
Yamur M. Obied ◽  
Thamir M. Abdul Wahhab
Keyword(s):  
Time Delay ◽  
Power System ◽  
Power Distribution ◽  
Software Package ◽  
Short Circuit ◽  
Distribution Network ◽  
Circuit Breaker ◽  
Short Circuit Current ◽  
Earth Fault ◽  
Current Characteristics

The coordination between protective devices is the process of determining the most appropriate timing of power interruption during abnormal conditions in the power system. The aim of this work is to coordinate the protection of the 33/11 kV power distribution substation in Iraq using the CYME 7.1 software package. In this paper overcurrent and earth fault relays are simulated in two cases, with time delay setting and instantaneous setting, to obtain the Time Current Characteristics (TCC) curves for each Circuit Breaker (CB) relay of Al-Karama substation (2×31.5 MVA, 33/11 kV) in Babil distribution network. The short circuit current at each CB is calculated and accordingly, the protection coordination for Al-Karama substation has been simulated. The TCC curves have been obtained in two cases for overcurrent and earth fault relays; in a case with time delay setting and in the case with the instantaneous setting. The setting takes into consideration the short circuit current at the furthest point of the longest outgoing feeder and the shortest outgoing feeder.

Power Plant Station Protection System against Voltage Fluctuation

2015 ◽  
Vol 793 ◽  
pp. 65-69 ◽  
Author(s):  
Abadal Salam T. Hussain ◽  
Waleed A. Oraibi ◽  
Fadhel A. Jumaa ◽  
F. Malek ◽  
Syed F. Ahmed ◽  
...  
Keyword(s):  
Power Plant ◽  
Power System ◽  
Short Circuit ◽  
Electrical Power ◽  
Circuit Breaker ◽  
Digital Signal ◽  
Short Circuit Current ◽  
Electrical Power System ◽  
System Protection ◽  
Protective Relay

Electrical Power System protection is required to protectboth the user and the system equipment itself fromany fault, hence electrical power system is not allowed to operate without any protection devices installed. Power System fault is defined as the undesirable condition that occurs in the power system. Some of these undesirable conditions are short circuit, current leakage, ground faultand over-under voltage. With the increasing loads, voltages and short-circuit duty in power plant, over voltage protection has become more important today. Here, the component that had been used is PIC 16F877a microcontroller to control the whole system and especially on the circuit breakers as well as the LCT display unit is used to display the voltage level and type of generator that used to serve the load. Sensors are used to measure both thevoltage and the load. The controlled digital signal from PIC microcontroller is converted by using the digital analog converter to control the whole circuit. Thus a device called protective relay is created to meet this requirement. The protective relay is mostlyoften coupled with circuit breaker in a way that it can isolate the abnormal condition in the system.

Sign in / Sign up

Export Citation Format

Share Document