scholarly journals Experimental and Numerical Research on the Formation Conditions and Entrainment Characteristics of Supercavity by Rear Jet Reflux

2022 ◽  
Vol 15 (1) ◽  
Author(s):  
S. G. Skublov ◽  
A. O. Krasotkina ◽  
A. B. Makeyev ◽  
O. L. Galankina ◽  
A. E. Melnik

Findings of the growth relationships between baddeleyite and zircon are rare, due to significant differences in the formation conditions of the minerals. A reaction replacement (partial to complete) of baddeleyite by zircon is possible during metamorphism accompanied by the interaction with high-Si fluids. The opposite situation, when zircon is replaced by baddeleyite, is extremely rare in the nature. Transformation of zircon from polymineral (compound) ore occurrence Ichetju (the Middle Timan) with the formation of microaggregates of baddeleyite, ratile and florencite has been found out. The size of the largest segregations of baddeleyite does not exceed 10 microns in diameter. Microaggregates are unevenly related to the rim of zircon with a thickness of 10 to 50 rfn, voids and cracks across the grain. Altered zircon rim (a mixture of newly formed minerals) is characterized by sharply increased composition of REE (especially LREE), Y, Nb, Ca, Ti. The composition of Th and U also increases. An overview of the experimental studies on the reaction between zircon and baddeleyite and single natural analogues allows to make a conclusion that the most likely mechanism of the transformation of zircon from ore occurrence Ichetju to baddeleyite (intergrowth with ratile and florencite) is due to the effect of interaction of primary zircon with high-temperature (higher than 500—600°C) alkaline fluids transporting HFSE (REE, Y, Nb, Ti). This is indirectly confirmed by the findings of zircon with anomalous high composition of Y and REE up to 100000 and 70000 ppm respectively.


The article is devoted to the actual problem of assigning optimal parameters for connecting steel plates on cover plates with angular welds that are widely used in construction practice. The article presents the results of a comprehensive study of operation of a welded assembly of the plates connection on cover plates. An algorithm is proposed for determining the optimal parameters of a welded joint with fillet welds on the cover plates, which makes it possible to obtain a strength balanced connection. The results of full-scale tensile tests of models were presented. These results confirmed the correctness of the assumed design assumptions, and made it possible to obtain a form of destruction, not characteristic and not described in the normative literature, expressed by cutting the main elements along the length of the overlap in the joint. The possibility of such a form of destruction was confirmed by the results of numerical research in a nonlinear formulation. The optimal parameters of the nodal welded joint determined by engineering calculation are confirmed by experimental studies, as well as by the results of numerical experiments on models of calculation schemes, taking into account the physical nonlinearity of the material operation. The obtained dependence for determining the bearing capacity of the joint by the cut-off mechanism and the expression for limiting the overlap length of the cover plates will make it possible to predict the nature of the fracture and design equally strong joints.


Sign in / Sign up

Export Citation Format

Share Document