The dynamics of the centreing mechanism of piercing mill mandrel of the pipe-rolling plant

The paper presents the results of the vibrodiagnostics of a centering machine mechanism for holding piercing mill mandrel N1 of the pipe-rolling plant (PRP) 350. In the paper, it is established that vibration acceleration of a bearing roller lever of the centering machine mechanism for holding piercing mill mandrel during milling of an Æ282х50 mm shell, steel 20 reaches 5…12 m/s2, and of the upper roller’s vibration frequency is 33.3 Hz. The paper presents the results of the thickness measuring of the Æ282х50 shell, steel 20 after using the piercing mill N1 350. The results shows the distinctive influence of the dynamics of the milling holding mechanism rod. The system is put forth for calculating the energy-power parameters during the realization of the technical process for making shells of the required specifications in a piercing mill. The paper establishes the value of the milling axial resistance to the flow of the milled metal (taking the calibration values into account). The paper presents a refined system for making a dynamic model for the piercing bill milling holding mechanism rod with the milling calibration parameters taken fully included. A differential equation for the milling rod movement is made, specifically for the dynamic model of the PRP piercing mill mechanical system. The dynamic values of the mechanical system are refined, which is used as a starting point for solving the tasks dealing with the analysis of the PRP piercing mill milling rod’s vibroactivity state. In order to decrease rod vibroactivity levels, the paper recommends choosing rational milling calibration and to set the shell milling modes using mechanical system dynamics modelling during the corresponding stages of the design of technological processes. The paper pro-poses a scheme for modernization of the PRP 350 piercing bill exit side by switching the centering machine rod system holding bridges gear to proportional hydraulics. Keywords: piercing mill, vibration diagnostics, thickness measurement, piercing, sleeve; difference in wall thickness, energy-power parameters, calibration, mandrel, vibroactivity, dynamics, mandrel retention mechanism.