The article deals with the task of simplifying the reverse design process by implementing three-point 3D scanning, which allows you to speed up the technological stages of reverse design to the moment of product manufacture, as well as simplify the procedure for defecating finished products and create favorable conditions for the implementation of the principles of unification. The model of the control system in this article refers to the structuring of elements of the technological organization of the process of creating 3D prototyping of existing copies created by the use of reverse engineering. For this purpose, the problems of traditional technologies that do not allow timely coping with changes in the technical system under the influence of in accordance with the requirements of regulatory documents and environmental requirements were considered. We also analyzed not only the principles of operation of traditional technologies, but also the zone of reverse engineering, which allows you to achieve an increased level of production capacity by identifying a group of key defects based on the process of flaw detection and statistical analysis.
In-line flaw detection of pultruded profiles by air-coupled ultrasound