Dual-band bandpass filter by using square-loop dual-mode resonator

2008 ◽  
Vol 50 (6) ◽  
pp. 1567-1570 ◽  
Author(s):  
Atallah Balalem ◽  
Jan Machac ◽  
Abbas Omar
Frequenz ◽  
2016 ◽  
Vol 70 (9-10) ◽  
Author(s):  
Chuanming Zhu ◽  
Jin Xu ◽  
Wei Kang ◽  
Zhenxin Hu ◽  
Wen Wu

AbstractIn this paper, a miniaturized dual-band bandpass filter (DB-BPF) using embedded dual-mode resonator (DMR) with controllable bandwidths is proposed. Two passbands are generated by two sets of resonators operating at two different frequencies. One set of resonators is utilized not only as the resonant elements that yield the lower passband, but also as the feeding structures with source-load coupling to excite the other to produce the upper passband. Sufficient degrees of freedom are achieved to control the center frequencies and bandwidths of two passbands. Moreover, multiple transmission zeros (TZs) are created to improve the passband selectivity of the filter. The design of the filter has been demonstrated by the measurement. The filter features not only miniaturized circuit sizes, low insertion loss, independently controllable central frequencies, but also controllable bandwidths and TZs.


2020 ◽  
Vol 71 (6) ◽  
pp. 433-435
Author(s):  
Shan Shan Gao ◽  
Jia-Lin Li ◽  
Zhe Lin Zhu ◽  
Jia Li Xu ◽  
Yong Xin Zhao

AbstractAn improved feedline configuration for dual-mode resonator filter is investigated in this paper. Based on the introduced topology, a dual-mode dual-band bandpass filter with center frequencies of 1.8 and 2.4 GHz is optimally designed, fabricated and tested. The introduced dual-band bandpass filter has simple structure and enables high selectivity to be realized due to two pairs of transmission zeros located near to the lower and upper passband, respectively. Both measured and simulated performances are presented with good consistency.


2013 ◽  
Vol 37 ◽  
pp. 95-106
Author(s):  
Shou Jia Sun ◽  
Shuai Yang ◽  
Bian Wu ◽  
Kun Deng ◽  
Chang-Hong Liang

2018 ◽  
Vol 11 (1) ◽  
Author(s):  
Raaed T. Hammed ◽  
Dhuha G. Hammood

This paper presents a miniaturized dual-band bandpass filter using two coupled dual-moderesonators (DMRs). The dual-mode resonator is a short-circuited stub loaded square loop resonator. The concept of miniaturization achieved using multilayered technology. Therefore, the filter circuits are achieved in three layers. On the first layer, two coupled dual-mode resonators are designed and shorted to a ground layer to specify the required passbands. Next, a second layer employs two shorted quarter wavelength stubs coupled through one via hole are capacitively coupled to the first layer circuit to achieve the filtering response. For our demonstration, a multi-band bandpass filter is designed to serve a multifunctional wireless system has centre frequencies of 1.9 GHz GSM and 3.5 GHz WiMax systems. The filter is implemented and simulated using the momentum simulator of the Advanced Design System (ADS) software package. The filter response has two second-order passbands with four transmission zeros leads to a high skirt selectivity. The filter circuit area is very small, less than 37 mm2 terminating the feeding ports.


Author(s):  
Baoping Ren ◽  
Haiwen Liu ◽  
Pin Wen ◽  
Xuehui Guan ◽  
Zhewang Ma

Sign in / Sign up

Export Citation Format

Share Document