Accelerated degradation test is an effective method to evaluate the reliability of products with long life and high reliability. The performance of most products fluctuates randomly in the degradation process, so it is suitable to use Wiener process. At present, the diffusion coefficient is regarded as constant in Wiener process, while the drift coefficient is related to stress. However, in practice, the amplitude of product performance fluctuation increases with the increase of stress level, which is not constant. Therefore, for the nonlinear Wiener case where both the drift coefficient and the diffusion coefficient are stress dependent, this paper studies the constant-stress accelerated degradation test theories and methods. Taking the contact pairs of electrical connectors as the research object, the minimum variance of reliable life estimate under normal stress is taken as the target. After determining the censored time at each stress level, the test stress level, the sample distribution ratio at each stress level, and the test interval at the one-third power scale of time are taken as design variables. The test plan under 3, 4, and 5 stress levels is optimized and compared with the general test plan. The influence of the difference between high and low stress levels on the evaluation accuracy is analyzed. Finally, the sensitivity analysis of parameters shows that the optimization plan has good robustness, and the change of stress quantity has little influence on the robustness of the plan.
Lifetime Assessment of POCT Strips through Accelerated Degradation Test
