Adaptive Control Constraint and Automatic Cut Distribution System for Turning Operations

1975 ◽  
pp. 71-78
Author(s):  
E. Gieseke
Keyword(s):  
Adaptive Control ◽  
Distribution System ◽  
Control Constraint ◽  
Turning Operations

Local balance-based adaptive control in the heat distribution system – Practical validation

2010 ◽  
Vol 30 (8-9) ◽  
pp. 879-891 ◽  
Author(s):  
Jacek Czeczot ◽  
Piotr Laszczyk ◽  
Mieczyslaw Metzger
Keyword(s):  
Adaptive Control ◽  
Distribution System ◽  
Heat Distribution ◽  
Practical Validation

Adaptive Control Constraint of Machining Processes

2001 ◽  
Vol 17 (10) ◽  
pp. 720-726 ◽  
Author(s):  
Y. Liu ◽  
T. Cheng ◽  
L. Zuo
Keyword(s):  
Adaptive Control ◽  
Control Constraint ◽  
Machining Processes

A Model-Based Approach to Adaptive Control Optimization in Milling

1986 ◽  
Vol 108 (1) ◽  
pp. 56-64 ◽  
Author(s):  
Tohru Watanabe
Keyword(s):  
Adaptive Control ◽  
Wear Rate ◽  
Tool Wear ◽  
Flank Wear ◽  
Physical Parameters ◽  
Total System ◽  
Control Constraint ◽  
Tool Wear Rate ◽  
Optimization System ◽  
Control Optimization

An adaptive control optimization system using a model to represent actual physical phenomena in milling is discussed. The model is used for the identification of physical parameters, the calculation of the temperature at the tool edges, and the estimation of the tool wear rate. The shear angle of the shear plane, the flank wear land length of the tool edge, the true contact area at the flank wear land, the radial depth and the axial depth of cut are identified as the physical parameters, the shear stress, and the hardness of the work material from bending moments and torque in the spindle generated by the cutting force. The temperature at the flank wear land is calculated from identified parameters. The tool wear is represented theoretically as the summation of the thermal, mechanical and shock wears. Each wear is calculated from identified parameters and the temperature at the tool edges. Adaptive control experiments to keep the tool-wear rate at a constant value verify that the total system works well. An adaptive control optimization system using the tool-wear rate equation is compared with an adaptive control constraint system using Taylor’s tool life equation in a computer simulation. The simulation shows that adaptive control optimization gives higher cost efficiency than adaptive control constraint when the process parameters vary.

Sign in / Sign up

Export Citation Format

Share Document