An Experimental Study Simulating the Helium Liquefaction Process in a Reciprocating Magnetic Refrigerator

1986 ◽  
pp. 763-769 ◽  
Author(s):  
Toyomi Fujita ◽  
Takashi Yazawa ◽  
Takasu Hashimoto ◽  
Hideki Nakagome ◽  
Toru Kuriyama
Keyword(s):  
Experimental Study ◽  
Magnetic Refrigerator ◽  
Liquefaction Process

scholarly journals Experimental study on the liquefaction process of iron concentrate on swing table

2020 ◽  
Vol 587 ◽  
pp. 012022
Author(s):  
Qian Weiwen ◽  
Zhang Jianwei ◽  
Wu Wenfeng ◽  
Lu Jinshu
Keyword(s):  
Experimental Study ◽  
Iron Concentrate ◽  
Liquefaction Process

scholarly journals 2D MODEL NUMERIC AMR, MODELLING AND SIMULATION OF MAGNETOCALORIC EFFECT

2021 ◽  
Vol 28 (1) ◽  
Author(s):  
Dorin Botoc ◽  
Keyword(s):  
Experimental Study ◽  
Differential Equations ◽  
Magnetocaloric Effect ◽  
Dipole Moments ◽  
Atomic Level ◽  
Modelling And Simulation ◽  
Magnetic Refrigerator ◽  
Prototype Development ◽  
Complex Cases ◽  
2D Model

In this article, the study of gadolinium material is focused on determining the constants and properties of the material, the analysis of substructures and the orientation of dipole moments. Research into material aspects provides important information on atomic-level sub-phenomena in the field of the main magnetocaloric phenomena for the magnetic refrigeration regenerator (AMR). The experimental study is mainly based on testing the magneto-caloric material with different magnetization equipment, developed to measure more precise and fine details, magnetic refrigerator, AMR prototype development and the like. The method used uses differential equations. For both cases, where the loads are relatively simple and for more complex cases, the method can be easily applied.

The Helium Magnetic Refrigerator II: Liquefaction Process and Efficiency

1984 ◽  
pp. 589-596 ◽  
Author(s):  
T. Numazawa ◽  
T. Hashimoto ◽  
H. Nakagome ◽  
N. Tanji ◽  
O. Horigami
Keyword(s):  
Magnetic Refrigerator ◽  
Liquefaction Process

Experimental study on the restoration from a tilt-azimuth series for improvement in resolution

1995 ◽  
Vol 53 ◽  
pp. 636-637
Author(s):  
Norio Baba ◽  
Norihiko Ichise ◽  
Syunya Watanabe
Keyword(s):  
Experimental Study ◽  
Spherical Aberration ◽  
Incident Beam ◽  
Optical Parameters ◽  
Beam Tilting ◽  
Illumination Method ◽  
Restoration Method ◽  
Illumination Mode

The tilted beam illumination method is used to improve the resolution comparing with the axial illumination mode. Using this advantage, a restoration method of several tilted beam images covering the full azimuthal range was proposed by Saxton, and experimentally examined. To make this technique more reliable it seems that some practical problems still remain. In this report the restoration was attempted and the problems were considered. In our study, four problems were pointed out for the experiment of the restoration. (1) Accurate beam tilt adjustment to fit the incident beam to the coma-free axis for the symmetrical beam tilting over the full azimuthal range. (2) Accurate measurements of the optical parameters which are necessary to design the restoration filter. Even if the spherical aberration coefficient Cs is known with accuracy and the axial astigmatism is sufficiently compensated, at least the defocus value must be measured. (3) Accurate alignment of the tilt-azimuth series images.

An Experimental Study of Some Properties of Stuttered Words

1962 ◽  
Vol 5 (4) ◽  
pp. 387-394 ◽  
Author(s):  
Bruce Quarrington ◽  
Jerome Conway ◽  
Nathan Siegel
Keyword(s):  
Experimental Study

Experimental study of total body washout employing extracorporeal circulation and hypothermia

1974 ◽  
Vol 126 (2) ◽  
pp. 243-248
Author(s):  
A WAKABAYASHI ◽  
T KUBO ◽  
K CHARNEY ◽  
Y NAKAMURA ◽  
J CONNOLLY
Keyword(s):  
Experimental Study ◽  
Extracorporeal Circulation ◽  
Total Body
Sign in / Sign up

Export Citation Format

Share Document