Delamination Identification of Laminated Composite Plates Using a Continuously Scanning Laser Doppler Vibrometer System

2018 ◽  
pp. 9-18
Author(s):  
Da-Ming Chen ◽  
Y. F. Xu ◽  
W. D. Zhu
Keyword(s):  
Laser Doppler Vibrometer ◽  
Laminated Composite ◽  
Composite Plates ◽  
Laser Doppler ◽  
Scanning Laser ◽  
Laminated Composite Plates ◽  
Scanning Laser Doppler Vibrometer

scholarly journals Non-Model-Based Identification of Delamination in Laminated Composite Plates Using a Continuously Scanning Laser Doppler Vibrometer System

2018 ◽  
Vol 140 (4) ◽  
Author(s):  
Da-Ming Chen ◽  
Y. F. Xu ◽  
W. D. Zhu
Keyword(s):  
Composite Structure ◽  
Composite Plate ◽  
Structural Damage ◽  
Laser Doppler Vibrometer ◽  
Laminated Composite ◽  
Composite Plates ◽  
Scanning Laser ◽  
Laminated Composite Plates ◽  
Scanning Laser Doppler Vibrometer ◽  
Local Anomalies

Delamination frequently occurs in a laminated composite structure and can cause prominent local anomalies in curvature vibration shapes associated with vibration shapes of the composite structure. Spatially dense vibration shapes of a structure can be rapidly obtained by use of a continuously scanning laser Doppler vibrometer (CSLDV) system, which sweeps its laser spot over a vibrating surface of the structure. This paper introduces a continuous scanning scheme for general quadrangular scan areas assigned on plates and extends two damage identification methods for beams to identify delamination in laminated composite plates using a CSLDV system. One method is based on the technique that a curvature vibration shape from a polynomial that fits a vibration shape of a damaged structure can well approximate an associated curvature vibration shape of an undamaged structure and local anomalies caused by structural damage can be identified by comparing the curvature vibration shape of the damaged structure with that from the polynomial fit, and the other is based on the technique that a continuous wavelet transform can directly identify local anomalies in a curvature vibration shape caused by structural damage. The two methods yield corresponding damage indices and local anomalies in curvature vibration shapes can be identified in neighborhoods with high damage index values. Both numerical and experimental investigations on effectiveness of the two methods are conducted on a laminated composite plate with a delamination area. In the experimental investigation, delamination identification results from the two methods were compared with that from a C-scan image of the composite plate.

Identification of pavement material properties using a scanning laser Doppler vibrometer

2016 ◽  
Author(s):  
Navid Hasheminejad ◽  
Cedric Vuye ◽  
Wim Van den Bergh ◽  
Joris Dirckx ◽  
Jari Leysen ◽  
...  
Keyword(s):  
Material Properties ◽  
Laser Doppler Vibrometer ◽  
Laser Doppler ◽  
Scanning Laser ◽  
Scanning Laser Doppler Vibrometer ◽  
Pavement Material

Scanning Laser Doppler Vibrometry of the Middle Ear Ossicles

1997 ◽  
Vol 76 (4) ◽  
pp. 213-222 ◽  
Author(s):  
Geoffrey R. Ball ◽  
Alex Huber ◽  
Richard L. Goode
Keyword(s):  
Middle Ear ◽  
Single Point ◽  
Three Dimensional ◽  
Laser Doppler Vibrometer ◽  
Ossicular Chain ◽  
Laser Doppler ◽  
Scanning Laser ◽  
Scanning Laser Doppler Vibrometer ◽  
Point Analysis ◽  
Ear Ossicles

This paper describes measurements of the vibratory modes of the middle ear ossicles made with a scanning laser Doppler vibrometer. Previous studies of the middle ear ossicles with single-point laser Doppler measurements have raised questions regarding the vibrational modes of the ossicular chain. Single-point analysis methods do not have the ability to measure multiple points on the ossicles and, consequently, have limited ability to simultaneously record relative phase information at these points. Using a Polytec Model PSV-100, detailed measurements of the ossicular chain have been completed in the human temporal bone model. This model, when driven with a middle ear transducer, provides detailed three-dimensional data of the vibrational patterns of the middle ear ossicles. Implications for middle ear implantable devices are discussed.

Sign in / Sign up

Export Citation Format

Share Document