Experimental study of low-temperature long-time relaxation in epoxy resin

1987 ◽  
Vol 68 (3-4) ◽  
pp. 285-299 ◽  
Author(s):  
M. Koláč ◽  
B. S. Neganov ◽  
A. Sahling ◽  
S. Sahling
1987 ◽  
Vol 26 (S3-2) ◽  
pp. 1699
Author(s):  
S. Sahling ◽  
A. Sahling ◽  
M. KOláč M. KOláč

Author(s):  
Е.В. Волкова

В данной статье обсуждается вопрос о возможности удачного обжига практически сырых глиняных сосудов в примитивных обжигательных устройствах: кострищах и очагах. Для исследования этого вопроса был поставлен эксперимент. Сосуды из трех разных формовочных масс с разной степенью высушености были обожжены в углубленном в грунт очаге в восстановительной среде длительное время (проведено 3 обжига) и в наземном очаге в полувосстановительной среде с использованием навоза коровы в качестве единственного топлива (1 обжиг). В результате автором были получены следующие выводы. Вопервых, для обжига в очаге с навозом в качестве основного топлива вполне пригодны сосуды 2 дневной сушки, т. е. практически сырые. Наилучшим образом обожглись сосуды, сделанные из глины и шамота. Для сосудов, слепленых из чистой глины и глины с навозом, имевший место подъем температуры был слишком резким и привел к образованию трещин. Возможно, при обжиге только во влажном навозе с более медленным подъемом температуры без трещин оказались бы все сосуды. Во вторых, можно считать почти установленным, что сосуды после 2 дневной сушки вполне пригодны для длительного низкотемпературного обжига в восстановительной среде. Но для полной веренности в этом необходимо проведение ряда дополнительных экспериментов. В третьих, оптимальным для обжига недосушенных сосудов является рецепт глина навоз шамот . The paper explores options for successful firing of basically wet clay vessels in primitive firing constructions such as fire pits and hearths. An experiment was carried out to study this issue. Vessels from three different masses of clay with different degrees of dryness were fired in a hearth sunk into soil in a reducing environment for a long time (three firings) and in a surface hearth in a partly reducing environment with the use of cattle manure as the only fuel (one firing). The following conclusions were derived. Firstly, firing in a hearth with manure as main fuel is quite suitable for vessels that were dried for two days, i. e. basically wet vessels. The best result from firing was obtained for vessels made from clay and chamotte. The increase in temperature was too steep for vessels made from pure clay and clay with manure resulting in cracks. Maybe, there would have been no cracks in any vessels in case of firing in wet manure with a more gradual increase in temperature. Secondly, it was established that, after two days of drying, vessels were quite ready for lengthy low temperature firing in a reducing environment. However, to be absolutely sure in this, additional experiments are needed. Thirdly, an optimal formula for firing underdried vessels is as follows: clay mature chamotte.


1988 ◽  
Vol 65 (9) ◽  
pp. 1031-1033 ◽  
Author(s):  
S. Sahling ◽  
A. Sahling ◽  
M. Koláč

Actuators ◽  
2021 ◽  
Vol 10 (5) ◽  
pp. 98
Author(s):  
Chao-Yong Shen ◽  
Xiang-Yun Huang ◽  
Yang-Yang Chen ◽  
Yu-Hong Ma

In this research we conducted a sensitivity experimental study where we explored the dependency of the shear strain on the seismic properties of bearings, namely lead rubber bearing (LRB) and super high damping rubber bearing (SHDR). The factors studied were vertical pressure, temperature, shear modulus of the inner rubber (G value), loading frequency, and loading sequence. Six specimens were adopted, i.e., three LRBs and three SHDR bearings. A series of test plans were designed. The seismic characteristics of the bearings were captured through a cyclic loading test, which included post-yield stiffness, characteristic strength, area of a single cycle of the hysteretic loop, equivalent stiffness, and equivalent damping ratio. A whole analysis of variances was then conducted. At the same time, to explore certain phenomena caused by the factors, an extended discussion was carried out. Test results showed that the temperature is the most dominant feature, whereas the G value is the least contributing factor, with the effect of the loading frequency and the loading sequence found between these two. The increment of the post-yielded stiffness for LRB from 100% to 25% is a significant reduction from a low temperature to high one. The slope of the characteristic strength versus the shear strain for LRB under high temperature is larger than the one under low temperature.


2004 ◽  
Vol 1 (12) ◽  
pp. 3614-3618 ◽  
Author(s):  
Yu.V. Medvedev ◽  
N.I. Mezin ◽  
Yu.M. Nikolaenko ◽  
A.E. Pigur ◽  
N.V. Shishkova ◽  
...  
Keyword(s):  

Sign in / Sign up

Export Citation Format

Share Document