Total oxidation of chlorinated hydrocarbons on LaMnO3 perovskite type catalyst

1997 ◽  
Vol 61 (2) ◽  
pp. 245-250 ◽  
Author(s):  
R. Schneider ◽  
D. Kiessling ◽  
R. Herzschuh ◽  
G. Wendt
1998 ◽  
Vol 19 (2) ◽  
pp. 143-151 ◽  
Author(s):  
D. Kießling ◽  
R. Schneider ◽  
P. Kraak ◽  
M. Haftendorn ◽  
G. Wendt

1999 ◽  
Vol 54 (1) ◽  
pp. 23-30 ◽  
Author(s):  
Katja Stephan ◽  
Maja Hackenberger ◽  
Dieter Kießling ◽  
Gerhard Wendt

Author(s):  
Tran Thi Thu Huyen ◽  
Dang Thi Minh Hue ◽  
Nguyen Thi Tuyet Mai ◽  
Tran Thi Luyen ◽  
Nguyen Thi Lan

Gases of m-xylene is one of the popurlar toxic pollutants in the exhaust gases, it is emitted into the environment from factories and engines because the fuel in the engine does not burn completely. The best solution in order to remove this toxic gases of m-xylene to protect the environment is transforming them completely into CO2 and H2O by catalysts. Perovskite of LaMnO3 is one of the catalysts that was synthesized and studied the catalytic properties in total oxidation of m-xylene in our previous report. Obtained results showed that the LaMnO3 perovskite has good catalytic characterizations such as large surface area and the amount of α-oxygen adsorbed on the catalyst is large too. So, it exhibits a good catalytic activity in total oxidation of m-xylene at relatively low reaction temperature. In present work, the reaction order  and kinetics of this reaction are determined. The obtained results demonstrated that the reaction order value with respect to m-xylene is equal to about 1, to oxygene is proximately equal to 0 and the order of reaction is equal to about 1. Based on reaction order data, it was thought that the pathway of m-xylene oxidation by air oxygen  over LaMnO3 may be followed through which the Langmuir - Hinshelwood mechanism. Keywords Catalyst, perovskite, oxidation, m-xylene, kinetics References [1] Penã M.A and Fierro J.L.G (2001), << Chemical Stuctures and Performance of Perovskite Oxide>>, Chem. Rev, 101, pp 1981-2018. [2] Seiyama T., Yamazoe N. and Eguchi K. (1985), <<Characterization and Activity of some Mixed Metal Oxide Catalysts>>, Ind. Eng. Chem. Prod. Res. Dev., 24, pp. 19-27.[3] [3] Van Santen R. A., Neurock M. (2006), Molecular Heterogeneous catalysis, Wiley – VCH, pp.62-244. [4] Petrovics, Terlecki - Baricevic A., Karanovic Lj., Kirilov - Stefanov P. , Zdujic M., Dondur V., Paneva D., Mitov I., Rakic V. (2008), <<LaMO3 (M = Mg, Ti, Fe) perovskite type oxides : Preparation, Characterization and Catalytic Properties in Methane deep Oxidation>>, Appl. Catal. B, Env., 79, pp. 186-198. [5] Spinicci R., Tofanari A., Faticanti M., Pettiti I. and Porta P. (2001), <<Hexane Total Oxidation on LaMO3 (M = Mn, Co, Fe) perovskite-type oxides>>, J. Mole. Catal., 176, pp. 247-252. [6] Trần Thị Thu Huyền, Nguyễn Thị Minh Hiền, Nguyễn Hữu Phú (2006), <<Study on the preparation of perovskite oxides La1-xSrxMnO3 (x = 0; 0,3; 0,5) by sol - gel citrate method and their catalytic activity for m-xylene toltal oxidation>>, Hội nghị xúc tác và hấp phụ toàn quốc lần thứ IV, Tp. Hồ Chí Minh, Tr. 477-482.[7] Trần Thị Thu Huyền, Nguyễn Thị Minh Hiền, Nguyễn Hữu Phú (2009), <<Nghiên cứu động học của phản ứng oxi hóa hoàn toàn m-xylen trên các xúc tác perovskit LaMnO3 và La0,7A0,3MnO3 (A = Sr, Ca, Mg)>>, Tạp chí Hóa học, T.47 (6A), Tr 132-136.[8] Geoffrey C. Bond, Catherine Louis, David T. Thompson (2006), <<Catalysis by Gold>>, Catalytic Science Series-Vol.6.


2002 ◽  
Vol 55 (12) ◽  
pp. 757 ◽  
Author(s):  
Min Chen ◽  
Huai-Qing Huang ◽  
Xiao-Ming Zheng ◽  
Michael A. Morris

Perovskite-type LaMnO3 catalysts were prepared by three different methods and tested for CO oxidation. The structural character of the catalysts was investigated by using powder X-ray diffraction (XRD) and transmission electron microscopy (TEM). All three different preparation methods resulted in nanostructured particles forming in the LaMnO3 catalysts. The crystallite size was in the range of 20 to 80 nm depending on the synthesis conditions. It was possible to synthesize the smallest particle size and a pure phase of perovskite-type LaMnO3 oxide by using a sol–gel method. The results also indicated that the CO total oxidation activity was related to the size of LaMnO3 particle and the structure formed.


1999 ◽  
Vol 47 (1-4) ◽  
pp. 429-435 ◽  
Author(s):  
Ralf Schneider ◽  
Dieter Kiessling ◽  
Gerhard Wendt ◽  
Wolfgang Burckhardt ◽  
Georg Winterstein

Sign in / Sign up

Export Citation Format

Share Document