scholarly journals Gamma-spectrometric measurement procedure for a clearance concept of radioactively contaminated mercury from nuclear facilities

Author(s):  
Larissa Klaß ◽  
Philipp Ritz ◽  
Marius Hirsch ◽  
John Kettler ◽  
Andreas Havenith ◽  
...  

AbstractRadioactive mercury waste constitutes a significant challenge, as no approved disposal concept yet exists for such waste in Germany. This work describes a decontamination and measurement procedure for a possible clearance of mercury from nuclear facilities and release into reuse or conventional hazardous waste disposal to reduce the amount of mercury in a nuclear repository. The measurement setup and procedure were developed and evaluated including Monte-Carlo N-Particle® Transport Code (MCNP® and Monte Carlo N-Particle® are registered trademarks owned by Los Alamos National Security, LLC, manager and operator of Los Alamos National Laboratory, (Werner 2018, Werner 2017)), simulations to ensure conservative assumptions during the measurements. Results from decontaminated mercury samples show that a clearance pursuant to the German regulations would be feasible.

Author(s):  
J. J. Balkey ◽  
J. F. Kleinsteuber ◽  
R. E. Wieneke

Los Alamos National Laboratory (LANL) is one of two design laboratories in the United States Department of Energy (DOE) weapons complex, with over 60 years of experience in handling hazardous and radioactive materials. Actinide research and development are performed in two nuclear facilities. The Plutonium Facility has been in operation since 1978, and the Chemistry and Metallurgy Research (CMR) Facility was built in 1952. The Nuclear Materials Technology (NMT) Division is responsible for operating both facilities in a safe and environmentally sound manner. At these NMT Division nuclear facilities, the primary hazards that are associated with chemicals and radioactive materials are well controlled, with minimal risk to the workforce and the public. Most workforce injuries are physical or ergonomic in nature. In an effort to increase safety awareness and to decrease accidents and incidents, a program focusing on identifying and eliminating unsafe behaviors was initiated. This process is named ATOMICS (for Allowing Timely Observations Measures Increased Commitment to Safety). Workers are trained on how to conduct safety observations of one another and given guidance on specific behaviors to note. Observations are structured to have minimal impact on the workload and are shared by the entire workforce. This program has effectively decreased an already low accident rate and will make long-term sustainability possible. The behavior-based safety process engages the workforce in the implementation and utilization of their own safety initative. The process is based on the simple act of having workers observe other workers and provide feedback on safe and at-risk behaviors. Observations typically take 10 to 15 minutes. Observations are strictly conducted under the conditions that no names are used and no blame is placed. A prospective observer takes 2 days of training on how to perform observations. To date, this behavioral safety program has been effective in further reducing the low accident/injury rate for the division. Most of the division’s workforce has taken observer training, and about half of those trained perform approximately 2500 observations per year on work conducted in NMT Division nuclear facilities.


Sign in / Sign up

Export Citation Format

Share Document