Rice Husk and Its Pretreatments for Bio-oil Production via Fast Pyrolysis: a Review

2019 ◽  
Vol 13 (1) ◽  
pp. 23-42 ◽  
Author(s):  
Siu Hua Chang
Cellulose ◽  
2019 ◽  
Vol 26 (15) ◽  
pp. 8465-8474 ◽  
Author(s):  
Yuna Ma ◽  
Huiyan Zhang ◽  
Huaizhou Yang ◽  
Yaping Zhang

Author(s):  
Marcos Antônio KLUNK ◽  
Sudipta DASGUPTA ◽  
Mohuli DAS

Rice husk is among the products that stand out in use, and it is used as an alternative source of energy. The use of rice husk as biomass in the feeding of pyrolytic reactors for power generation and chemical products can reduce the environmental problem destination of this waste. The advantages of this process are in the proper disposal of this waste and energy generation. Fast pyrolysis of the rice husk was carried out in temperatures of 400-600°C. This work aims to evaluate the influence of temperature on yield and product composition of the gas, bio-oil, and char. The yield of bio-oil proved to be efficient (62 wt.% at 450°C) due to the high heat transfer and mass, as well as the residence time in the reactor. In addition, bio-oil production decreases slightly due to increased gas yield (1 to 15 wt.%) as the temperature increases in the range of 400-600°C, with the composition being severely affected, i.e., The concentration of CO increases and that of CO2 decreases. In addition, a slight increase in the concentration of CH4 and C2-C4 hydrocarbons occurs with increasing temperature. The yield of char at 400°C and 600°C was 41.14-34.77 wt.%, respectively, corresponding to a decrease of 16 wt.%. The char obtained is of low heating value but has good features for the production of active carbons and amorphous silica. These results demonstrate the efficiency and optimization of the fast pyrolysis of rice husk, in order to obtain biooil and char.


Energy ◽  
2018 ◽  
Vol 154 ◽  
pp. 477-487 ◽  
Author(s):  
Wenfei Cai ◽  
Li Dai ◽  
Ronghou Liu

Fuel ◽  
2014 ◽  
Vol 128 ◽  
pp. 162-169 ◽  
Author(s):  
Jon Alvarez ◽  
Gartzen Lopez ◽  
Maider Amutio ◽  
Javier Bilbao ◽  
Martin Olazar

2021 ◽  
Vol 38 (2) ◽  
pp. 306-315
Author(s):  
Hoang Vu Ly ◽  
Quoc Khanh Tran ◽  
Byung Hee Chun ◽  
Changho Oh ◽  
Jinsoo Kim ◽  
...  

Fuel ◽  
2017 ◽  
Vol 207 ◽  
pp. 71-84 ◽  
Author(s):  
Chamseddine Guizani ◽  
Sylvie Valin ◽  
Joseph Billaud ◽  
Marine Peyrot ◽  
Sylvain Salvador

2020 ◽  
Vol 58 (5) ◽  
pp. 604
Author(s):  
Hong Nam Nguyen ◽  
Bùi Văn Đức ◽  
Ngoc Linh Vu ◽  
Hong Nam Nguyen ◽  
Thi Thu Ha Vu ◽  
...  

Despite its prominent potential, the use of rubber wood (Hevea brasiliensis) for bio-oil production has not been fully investigated. This study reported experimental results of the bio-oil production and upgrading from rubber wood using fast pyrolysis technology. The effects of catalyst nature (vermiculite and dolomite), upgrading temperature and bio-oil/catalyst ratio on the product quality were deeply investigated. The results showed that dolomite was suitable to be used as a catalyst for bio-oil upgrading. At 600 °C and a bio-oil/catalyst ratio of 1:1, the bio-oil yield was maximized, while at 400 °C and a ratio of 1:3, the bio-oil heating value was maximized. Depending on usage purposes, a yield-oriented, heating value-oriented or in-between bio-oil upgrading solution could be considered.


Energy ◽  
2019 ◽  
Vol 186 ◽  
pp. 115882 ◽  
Author(s):  
Wenfei Cai ◽  
Ning Kang ◽  
Moon Ki Jang ◽  
Chen Sun ◽  
Ronghou Liu ◽  
...  

2007 ◽  
Vol 310 (1) ◽  
pp. 57-73 ◽  
Author(s):  
Dinesh Mohan ◽  
Charles U. Pittman ◽  
Mark Bricka ◽  
Fran Smith ◽  
Ben Yancey ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document