Thermal performance of a solar still coupled with an inexpensive ground water heater

1983 ◽  
Vol 23 (4) ◽  
pp. 221-230 ◽  
Author(s):  
M.S. Reddy
2021 ◽  
Vol 13 (22) ◽  
pp. 12414
Author(s):  
Naseer T. Alwan ◽  
Sergey E. Shcheklein ◽  
Obed Majeed Ali ◽  
Milia H. Majeed ◽  
Ephraim Bonah Agyekum

One of the key impediments to the wide utilization of solar water desalination systems is limited production. Hence, this study aims at increasing the thermal performance of a single-slope solar still by increasing the surface area of evaporation and absorption exposed to sunlight. A hollow rotating cylinder was installed inside the still structure; this modified system was then joined with an outside solar water heater for productivity improvement. The obtained results show that a 0.5 rpm rotational speed ensured that the cylinder’s surface was kept wet. A mathematical model has been formulated using the finite difference method and the Fortran 90 programming language to assess the thermal performance productivity of two solar stills (conventional solar still (CSS) and modified solar still (MSS)) modelled under different conditions. The experimental and theoretical results are well agreed, with an error of 6.14%. The obtained results show that the maximum productivity recorded in July 2019 was about 11.1 L/m2 from the MSS and 2.8 L/m2 from the CSS, with an improvement rate ranging between 286% and 300% during June, July, August, and September 2019. The production cost per liter of distilled water from the modified and conventional solar stills was 0.0302 USD/L and 0.0312 USD/L, respectively, which indicates a noticeable reduction in the cost of distillate water production.


Desalination ◽  
2013 ◽  
Vol 325 ◽  
pp. 56-64 ◽  
Author(s):  
Z.M. Omara ◽  
Mohamed A. Eltawil ◽  
ElSayed A. ElNashar

2020 ◽  
Vol 190 ◽  
pp. 00022
Author(s):  
Lia Hamanda ◽  
Gunawan Nugroho

The aim of this work is to study a mathematical modelling and simulation for predicting the thermal performance heat-pipe evacuated a solar collector for water heater, which was considered the temperature distribution along the tube axis and radius. This model used to help in studying the dynamic behaviour of the system design and the effect of influential parameter on the water heater process. The result showed that water heating is affected by the surface of collector, metrological conditions such as solar radiation and outdoor temperature, even the thermal performance of the collector.


Author(s):  
Amit K. Bhakta ◽  
Nitesh K. Panday ◽  
Shailenrda N. Singh

This paper reports the overall thermal performance of a cylindrical parabolic concentrating solar water heater (CPCSWH) with inserting nail type twisted tape (NTT) in the copper absorber tube for the nail twist pitch ratios 4.787, 6.914 and 9.042 respectively. The experiments are conducted for a constant volumetric water flow rate and during the time period 9:00 h to 15:00 h. The useful heat gain, hourly solar energy collected and hourly solar energy stored of this solar water heater are found higher for nail twist pitch ratio 4.787. The above said parameters are found to be a peak at noon and observed to follow the path of variation of solar intensity. At the starting of the experiment, the value of charging efficiency is observed to be maximum. Whereas the maximum value of instantaneous efficiency and overall thermal efficiency are observed at noon. The key finding is that the nail twist pitch ratio enhances the overall thermal performance of the CPCSWH.


2021 ◽  
Author(s):  
Jamie Fine

Society’s use of fossil fuels has led to increasingly high levels of CO2 in the atmosphere. These levels have been linked to global average temperature rises, and increases in the severity and frequency of major weather events. To combat these effects, nations around the world have committed to reducing their CO2 emissions, and transition to renewable energy. This thesis focuses on the development of a novel solar heating system, which combines a hybrid solar panel and cascade heat pump. The thesis begins by presenting a high-level literature review of solar and heat pump technologies, followed by the initial design development of the system. Two design iterations are presented, illustrating that the final design was selected because it exhibits improved peak heat output, and reduced sensitivity to panel temperature. Next, a manuscript-based chapter is presented that focuses on utilizing the proposed solar heating system for water distillation. Case studies are presented that compare the performance of the proposed system with a solar still at four different locations. The final conclusion from these studies is that using the proposed system offers area-based performance improvements of 780% compared to a basic solar still. A second manuscript-based study is then presented, which focuses on utilizing the proposed solar heating system for domestic hot water production. Additional case studies are detailed that compare the proposed system to an evacuated tube design, and a single heat pump. The conclusions from these studies are that the proposed system exceeds the performance of the evacuated tube system by up to 64%, and that the proposed system is most beneficial during seasons with higher average dry-bulb temperatures, and increased solar irradiation. A final manuscript-based study is then presented, which focuses on a methodology for improving alternate mode thermal performance estimates for hybrid solar panels. The conclusion from this study is that the proposed methodology can successfully estimate thermal performance within 5% of actual values. Each of these studies contributes to the project goal of developing a novel solar energy heating system, which can be further developed to reduce global CO2 emissions, and reduce the effects of climate change.


2021 ◽  
Author(s):  
Jamie Fine

Society’s use of fossil fuels has led to increasingly high levels of CO2 in the atmosphere. These levels have been linked to global average temperature rises, and increases in the severity and frequency of major weather events. To combat these effects, nations around the world have committed to reducing their CO2 emissions, and transition to renewable energy. This thesis focuses on the development of a novel solar heating system, which combines a hybrid solar panel and cascade heat pump. The thesis begins by presenting a high-level literature review of solar and heat pump technologies, followed by the initial design development of the system. Two design iterations are presented, illustrating that the final design was selected because it exhibits improved peak heat output, and reduced sensitivity to panel temperature. Next, a manuscript-based chapter is presented that focuses on utilizing the proposed solar heating system for water distillation. Case studies are presented that compare the performance of the proposed system with a solar still at four different locations. The final conclusion from these studies is that using the proposed system offers area-based performance improvements of 780% compared to a basic solar still. A second manuscript-based study is then presented, which focuses on utilizing the proposed solar heating system for domestic hot water production. Additional case studies are detailed that compare the proposed system to an evacuated tube design, and a single heat pump. The conclusions from these studies are that the proposed system exceeds the performance of the evacuated tube system by up to 64%, and that the proposed system is most beneficial during seasons with higher average dry-bulb temperatures, and increased solar irradiation. A final manuscript-based study is then presented, which focuses on a methodology for improving alternate mode thermal performance estimates for hybrid solar panels. The conclusion from this study is that the proposed methodology can successfully estimate thermal performance within 5% of actual values. Each of these studies contributes to the project goal of developing a novel solar energy heating system, which can be further developed to reduce global CO2 emissions, and reduce the effects of climate change.


Author(s):  
Rinaldo H. Malau ◽  
Hideki Kawai ◽  
Himsar Ambarita ◽  
Dandy R. Tampubolon ◽  
Wahyu M. Silalahi

Sign in / Sign up

Export Citation Format

Share Document